5
SECTION 2: ASSEMBLING YOUR SNOW THROWER
NOTE: Any reference in this manual to the left or right
side of the snow thrower is observed from the
operator’s position.
Unpacking
•
Remove screws from the top sides and ends of the
shipping crate.
•
Set panel aside to avoid tire punctures or personal
injury.
•
Remove and discard plastic bag that covers unit.
•
Remove any loose parts included with unit (i.e.,
Operator’s Manual, etc).
•
Roll unit out of crate.
Loose Parts
The augers are secured to the auger shaft with two
shear bolts and hex lock nuts. If you hit a foreign object
or ice jam, the snow thrower is designed so that the
bolts may shear. Two replacement shear bolts and nuts
are provided for your convenience. Store in a safe
place until needed. See Figure 1.
Figure 1
Assembly
WARNING: Disconnect the spark plug
wire and ground it against the engine to
prevent unintended starting.
•
Remove the lower two plastic wing knobs, cupped
washers and carriage bolt (eyebolt on the left side)
from the lower handle. See Figure 2.
Figure 2
•
Raise the upper handle assembly until it locks over
the lower handle.
•
Look at the lower rear of snow thrower frame to be
sure both cables are aligned with cable roller
guides.
•
Secure the upper handle and lower handle with the
two plastic wing knobs, cupped washers and
carriage bolt (eyebolt on the left side) previously
removed. See Figure 3.
Figure 3
•
Adjust the eyebolt on the chute directional control
so the rod does nut come into contact with the
engine by moving the hex nut against the handle (if
necessary). Retighten the wing nut to secure the
directional control in this position.
•
Slide the shift rod connector down over the end of
the lower shift rod. Tap the connector until it locks
on the lower shift rod. See Figure 3.
NOTE: If the connector is not properly assembled, the
shift rod will pivot and you will not be able to change
speeds or change directions.
•
If not already attached, slip the cables that run from
the handle panel to the chute into the cable guide
located on top of the engine. See Figure 4.
Figure 4
•
Unwrap the headlight wire, which is attached to the
headlight beneath the handle panel.
Shear Bolts
Hex Lock
Nuts
Eyebolt
Wing Knobs, Washers,
& Bolts
Eyebolt
Wing Knobs
Connector
Hex Nut
Cable Guide
Содержание Yard Boss 550
Страница 22: ...22 Models 550 750 1 2 3 4 5 6 7 4 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 ...
Страница 26: ...26 ...
Страница 27: ...27 ...
