20
•
Using a feeler gauge, check the gap between the
brake disc and the brake puck. Proper gap is
0.011".
•
Tighten the crown nut until the proper gap is
achieved.
•
Install a new cotter pin (part 714-0111) on the
crown nut.
Figure 19
STEERING ADJUSTMENT
If the tractor turns tighter in one direction than the other,
or if the ball joints are being replaced due to damage or
wear, the steering drag links may need to be adjusted.
Adjust the drag links so that equal lengths are threaded
into the ball joint on the left side and the ball joint on the
right side:
•
Loosen the jam nut found on the drag link at the
rear of the ball joint. See Figure 20.
•
Remove the hex nut and lock washer on the top of
ball joint. See Figure 20.
Figure 20
•
Thread the ball joint toward the jam nut to shorten
the drag link. Thread the ball joint away from the
jam nut to lengthen the drag link.
•
Replace hex nut and lock washer and retighten the
jam nut after proper adjustment is achieved.
NOTE:
Threading the ball joints too far onto the drag
links will cause the front tires to "toe-in" too far. Proper
toe-in is between 1/16" and 5/16".
Front tire toe-in can be measured as follows:
•
Place the steering wheel in position for straight
ahead travel.
•
In front of the axle, measure the distance
horizontally from the inside of the left rim to the
inside of the right rim. Note the distance.
•
Behind the axle, measure the distance horizontally
from the inside of the left rim to the inside of the
right rim. Note the distance.
•
The measurement taken in front of the axle should
be between 1/16" and 5/16" less than the
measurement taken behind the axle.
•
Adjust if necessary.
SECTION 8: MAINTENANCE
WARNING:
Before performing any
maintenance or repairs, disengage PTO,
move shift lever into neutral position, set
parking brake, stop engine and remove key to
prevent unintended starting.
CLEANING THE ENGINE AND DECK
Any fuel or oil spilled on the machine should be wiped
off promptly.
Do NOT allow debris to accumulate around the cooling
fins of the engine or on any other part of the machine,
especially the belts and pulleys.
IMPORTANT:
The use of a pressure washer or
garden hose to clean your tractor is NOT
recommended. It may cause damage to electrical
components, spindles, pulleys, bearings or the engine.
The use of water will result in a shortened life of the
tractor and reduce its serviceability.
Deck Wash System (Optional)
Your tractor’s deck is equipped with water ports on its
surface as part of its deck wash system.
Use the Deck Wash System to rinse grass clippings
from the deck’s underside and prevent build-up of
corrosive chemicals. Complete the following steps after
each mowing:
1.
Drive the tractor to a level, clear spot on your lawn,
near enough to a water sillcock (spigot) for your
garden hose to reach.
Brake Disc
Crown Nut
NOTE:
View shown from beneath tractor.
Hydrostatic
Transmission
Brake Rod
Drag Link
Ball Joint
Axle
Pivot Bar
Hex Nut and
Jam Nut
Lock Washer
Zerk Fitting
(if so equipped)
Содержание LT-180H
Страница 29: ...NOTES 51 ...
