'PSNPEFMTXJUINBOVBM150DBSFGVMMZSFNPWFUIF
deck engage cable from the rear of the cutting deck by
removing the bow-tie cotter clip that secures it. Remove
UIFTQSJOHGSPNUIFEFDLJEMFSCSBDLFU4FF'JH
Remove the cotter pin from the end of the stabilizer rod
10.
and slide the stabilizer out of the hanger bracket on the
EFDL4FF'JH
(FOUMZTMJEFUIFDVUUJOHEFDL GSPNUIFSJHIUTJEFPVUGSPN
11.
underneath the tractor.
Changing the Deck Belt
8"3/*/(
The V-belts found on your tractor are
specially designed to engage and disengage safely.
"TVCTUJUVUF OPO0&.7CFMUDBOCFEBOHFSPVTCZ
not disengaging completely. For a proper working
machine, use factory approved belts.
"MMCFMUTPOZPVSUSBDUPSBSFTVCKFDUUPXFBSBOETIPVMECF
replaced if any signs of wear are present . To change or replace
the deck belt on your tractor, proceed as follows:
Remove the deck as previously instructed.
1.
Remove the belt covers by removing the hex washer
2.
TDSFXTUIBUGBTUFOUIFNUPUIFEFDL4FF'JH
It may also be necessary to loosen the hex nut on the left
3.
idler pulley to get the belt off the pulley and around the
belt guard.
Carefully remove the deck belt from around the two
TQJOEMFQVMMFZTBOEUIFUXPEFDLJEMFSQVMMFZT4FF'JH
'JHVSF
'JHVSF.PEFMTXJUINBOVBM150POMZ
)FY8BTIFS4DSFXT
#FMU$PWFS
%FDL*EMFS1VMMFZ
4QJOEMF1VMMFZ
#FMU(VBSE
'JHVSF
S
ECTION
7 — S
ERVICE