White Knight WK1543, Инструкция по эксплуатации

Страница: 6 / 63

5
Installation Instruction
Installation Requirements
The appliance should be placed in a dry and well-ventilated room. Since the performance
and energy consumption of the refrigerator can be affected by the ambient temperature, the
following instructions should be ensured:
- Don't expose the appliance to direct sunlight,
- Don't install the appliance close to radiators, cookers or other sources of heat,
- Place the appliance at a location where the ambient temperature corresponds to the
climate classification for which it is designed. You can find the climate classification on the
circuit-diagram-serial-plate located at the left-upper side of the appliance. The following
table shows this climate classification and its matching ambient temperature:
Climate classification Ambient temperature
SN 10~32°C
N 16~32°C
ST 16~38°C
T 16~43°C
Your appliance will be heavy when loaded with foods and must therefore be placed on a
strong firm floor and ensure the power socket is accessible.
Ventilation Requirements
Ensure that the air could circulate freely around the cabinet. There should be 100mm
between the top of the appliance and any overhanging furniture, and a gap of 25mm on
either side of the appliance.
Ensure that the appliance does not stand on the electrical supply cable. Parts that heat up
should not be exposed. Whenever possible the back of the appliance should be close to a
wall but remember to leave the suitable distance required for ventilation.
Leveling
The appliance should be level in order to eliminate rocking. To make the appliance level, it
should be upright and both adjusters should be firmly contacted with the floor. You can also
adjust the level by screwing out the appropriate level adjuster at the front (use your fingers or
a suitable spanner), but much care should be taken when moving this appliance since it
should be heavy.
The supply cord
Care must be taken to ensure that the appliance does not stand on the electrical supply
cable. if the supply cord is damaged, it must be replaced by a special cord or assembly
available from the manufacturer or its service agent.