WA
15S
Operation Manual rev 1.0.0
5. Polarity Checking
5
5. Polarity Checking
Checking the polarity of the wiring before the speaker system is mounted or flown will help ensure satisfactory
performance. If you do not have a pulse based polarity checker, you may check LF units as follows: Connect
two wires to the + and - terminals of a PP3 (9 V) battery. Apply the wire connected to the positive (+) terminal
of the battery to the speaker cable leg which you believe to be connected to pin 1+ of the speaker connector;
likewise connect the negative (-) terminal of the battery to pin 1-.
If you have wired it correctly, the LF drive unit will move forward. At this point, connect the positive (+) speaker
lead to the + terminal on the amplifier and the negative (-) lead to the - terminal on the amplifier. However, if the
LF driver moves backwards with the battery test, the input connections need to be inverted before connecting
the amplifier.
If problems are encountered, inspect the cable wiring. Note that different amplifier manufacturers may
utilise different pin configurations and polarity conventions; if you are using amplifiers from more than one
manufacturer, check the polarity at the amplifiers as well as at the loudspeakers.
6. Amplification and Power Handling
As with all professional loudspeaker systems, the power handling is a function of voice coil thermal capacity.
Care should be taken to avoid overdriving the amplifier into clipping. Damage to the loudspeaker will be
sustained if the amplifier is driven into clipping for any extended period of time. Headroom of at least 3 dB
should be allowed.
When evaluating an amplifier, it is important to take into account its behaviour under low impedance load
conditions. A loudspeaker system is highly reactive, and with transient signals it can require more current than
the nominal impedance would indicate. Generally a higher power amplifier running free of distortion will do less
damage to the loudspeaker than a lower power amplifier that is continually clipping. A high powered amplifier
running at less than 90% of output power generally sounds superior to a lower power amplifier running at
100%. An amplifier with insufficient drive capability will not allow the full performance or the loudspeaker to be
realised. (See technical specifications section for recommended amplifier power.)
When using amplifiers from different manufacturers in a single installation, make certain that all have very
closely matched gains. (Variation should be less than +/- 0.5 dB.) This precaution is important to the overall
system balance when only a single active crossover is being used with multiple cabinets. When possible, it is
recommended that the same amplifiers be used throughout.
