Whirlpool WWDC 9614 S, Инструкция по эксплуатации

Страница: 26 / 38

26
WARNING
Make sure that the washer dryer has been shut
off and disconnected from its electrical power
supply before cleaning the water filter or draining
the residual water .If a high temperature wash
programme has recently been used, wait for the
water to cool before draining it .
The water filter should be cleaned regularly in
order to prevent water from remaining inside
the appliance after wash cycles due to filter
obstructions .
CLEANING THE WATER FILTER /
DRAINING THE RESIDUAL WATER
1 .
Remove the kick panel: Using a screwdriver,
do that which is shown in the following figure .
2 .
Container for the drained water:
Place a low and wide container under the water
filter in order to collect the residual water .
3 .
Drain the water:
Slowly turn the filter counter-clockwise until all the
water has come out .Allow the water to flow out
without removing the filter .
Once the container is full, close the water filter by
turning it clockwise . Empty the container . Repeat
the procedure until all the water has been drained .
4 .
Remove the filter: Place a cotton cloth under
the water filter in order to absorb any small
amounts of residual water . Next, remove the water
filter by turning it counter-clockwise .