13
3- Lock/Unlock
At non-lock state (the 4 icon shows ), Press
D
key for 3
seconds, the refrigerator will go into the state of Locked and
the
4
icon shows .
Press
D
key for 3 seconds persistently at the Locked state,
the
4
icon shows and the Locked state releases.
The following functions must be in operation under the
unlocked state.
Press mode button (
button B
), you can choose running mode
as the following.
Vacation Quick-freezer Quick-cold and freezer Quick-cold None
The following settings must be valid upon locking.
4- Vacation mode
Press
B
key to select Vacation mode, the
1
icon shows, then
press
D
key to confirm, the refrigerator will be running
according to Vacation mode.
5- Rapid cooling mode
Press
B
key to select Rapid cooling mode, the
3
icon shows,
then press
D
key to confirm, the refrigerator will be running
according to Rapid cooling mode.
6- Quick-freezer mode
Press
B
key to choose Quick-freeze mode, the
2
icon shows,
then press
D
key to confirm, the refrigerator will be running
according to Quick-freezer mode.
7- Refrigerator compartment temperature settings
Press
C
key once, the Refrigerator compartment temperature
displays with flashing, press
C
key again and you can set the
temperature, the range of temperature is from 2 °C to 8 °C.
8- Freezer compartment temperature settings.
Press
A
key once, the freezer compartment temperature
displays with flashing, press
D
key again and you can set the
temperature, the range of temperature is from -16 °C to -24 °C.
NOTE:
When the set temperature of freezer changes, if set
relevant function mode (e.g. quick-cold mode, quick-freezer
mode, quick-cold and freezer mode, vacation mode), the
relevant function mode should be quitted or canceled at once.
Water and ice dispensers
NOTES:
■
The dispensing system will not operate when freezer door is
open.
■
Allow 24 hours for the refrigerator to cool down and chill
water.
■
Allow 24 hours to produce the first batch of ice. Discard the
first three batches of ice produced. Wait 72 hours for full ice
production.
■
The display control screen on the freezer door panel will turn
off automatically and enter “sleep” mode when the control
buttons and dispenser pads have not been used for 2
minutes or more. While in “sleep” mode, the first press of a
control button will only reactivate the display screen, without
changing any settings.
Flush the water system
Air in the water dispensing system can cause the water
dispenser to drip. After connecting the refrigerator to a water
source or replacing the water filter, flush the water system.
Flushing the water dispensing system forces air from the water
line and filter, and prepares the water filter for use.
NOTE:
As air is cleared from the system, water may spurt out
of the dispenser.
1.
Using a sturdy container, depress and hold the water
dispenser pad for 5 seconds, then release it for 5 seconds.
2.
Repeat Step 1 until water begins to flow.
3.
Once water begins to flow, continue depressing and releasing
the dispenser pad (5 seconds on, 5 seconds off) until a total
of 3 gal (12 L) has been dispensed.
Additional flushing may be required in some households.
ENGLISH
