5
Unpack the Water Cooler
IMPORTANT:
■
Allow the water cooler to stand upright for a minimum of
1 hour after unpacking it and before plugging it into an
electrical outlet. This allows the refrigerant to settle properly
and avoids damage to the cooling system.
■
Remove the plastic bag and discard.
■
Remove tape from drip tray and discard.
■
Dispose of/recycle all packaging materials.
Location Requirements
NOTE: This water cooler is recommended for indoor use only.
Check location where water cooler will be installed. The location
must provide:
■
A 2" (5 cm) clearance between the water cooler and the wall.
IMPORTANT: For best performance, do not place the water
cooler near an open flame, radiator or other heat source.
■
Grounded 3 prong outlet.
■
Install where water cooler is protected from the elements.
Protect against freezing to avoid possible rupture of drain
line. Such ruptures are not covered by the warranty. See
“Storing” in the “Water Cooler Care” section for winter
storage information.
If the water cooler will be left unused for a period of time or in a
location where it may be subject to freezing, follow the
instructions in “Storing.”
Electrical Requirements
A 120 volt, 60 Hz, AC only, 15- or 20-amp fused, grounded
electrical supply is required.
WATER COOLER USE
NOTE: Clean baffle and reservoir thoroughly before first using
your water cooler and during normal maintenance operations.
See “Water Cooler Care.”
Water Cooler Preparation
1. Install water bottle.
2. Make sure water bottle lies firmly on the top of the water
cooler. If it does not, reposition the water bottle until it is
firmly seated.
3. Wait 5 minutes and then check to see that water flows easily
from both taps.
4. Plug into a grounded 3 prong outlet.
5. Press the power button located on the front of the water
cooler so that the green power light remains lit.
6. The thermostat is factory set. You must wait approximately
1 hour for the water to reach optimal temperature.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
water cooler and bottles.
Failure to do so can result in back or other injury.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
WARNING
Excessive Weight Hazard
Use two or more people to move and install
water cooler and bottles.
Failure to do so can result in back or other injury.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
