Step F - Connect Tubes (cont.)
16
ROUTEYELLOWTUBETOSTORAGETANK
1
. Locate the yellow tube attached to the Reverse Osmosis
filter assembly.
2
. Route the loose end of the yellow tube to the fitting on top
of the storage tank. See Fig. 23.
3
. Cut tube square and to length. See Fig. 18.
4
. Do not connect at this time. This will occur in the sanitizing
step.
CONNECTGREENTUBETOCOLDWATER
SUPPLYPIPE
1
. Route one end of the 1/4” green tube to the fitting on the
water supply pipe. See Fig. 23.
2
. Cut tube square and to length. See Fig. 18.
3
. Connect to cold water supply fitting. See Fig. 6.
4
. Route the other end of the green tube to green collet to the
fitting on the left side of the Reverse Osmosis filter
assembly.
5
. Cut tube square and to length. See Fig. 18.
6
. Insert all the way into the fitting. See Figs. 19 & 20.
7
. Pull on the tube to be sure it is held firmly in the fitting.
CONNECTBLUETUBETOREVERSEOSMOSIS
ASSEMBLY
1
. Locate the blue tube attached to the faucet.
2
. Route the loose end of the 3/8" blue tube to the blue collet
on the right side of the Reverse Osmosis filter assembly.
3
. Cut tube square and to length. See Fig. 18.
4
. Insert all the way into the fitting. See Figs. 19 & 20.
5
. Pull on the tube to be sure it's held firmly in the fitting.
CONNECTBLACKTUBEFROMREVERSE
OSMOSISFAUCETTODRAINADAPTER
1
. Locate the 3/8" black tube attached to the faucet. Fig 23.
2
. The loose end needs to be attached to the black collet on
the sink drain adapter.
3
. Cut this tube as needed to route it as straight as possible,
without loops, dips, or kinks.
4
. Cut the end of the tube square. See Fig. 18.
5
. Insert all the way into the fitting. See Figs. 19 & 20.
6
. Pull on the tube to be sure it is held firmly in the fitting.
REDTUBETOREVERSEOSMOSISFAUCET
The red tube connection was completed in the faucet
assembly steps.
NOTE:Tubinglengthsshouldallowforthe
removaloftheassemblyfromthehanger
washersforservicing.Iftubinglengthsare
shortenedforneaterappearance,itmaybe
necessarytokeeptheassemblyonthe
hangerwashersforservice.
NOTE:CodesinthestateofMassachusetts
requireinstallationbyalicensedplumber
anddonotpermittheuseofsaddlevalves.
IfyouliveinthestateofMassachusetts,
reviewplumbingcode248-CMRofthe
CommonwealthofMassachusettsbefore
proceedingwiththeinstallation.
NOTE:Tubecolors
matchcolletcolors.
TubeConnections
FIG.23
Tubing Connector
Drain
Adapter
3/8” BLACK
Tubing
Sink
P–Trap
3/8”
BLUE
1/4”
RED
1/4”
GREEN
3/8”
YELLOW
HOT COLD
Tee, Feed
Adapter
