COMPONENT ACCESS
Whirlpool & Maytag 9.2 Cu. Ft. Steam Dryer
n
4-15
Removing the Gas Burner Assembly Coils (Gas Models Only)
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
To Remove the Ignitor, Flame Sensor, High-Limit
Thermostat and Thermal Cutoff (Gas Models Only)
1.
Unplug dryer or disconnect power.
2.
Turn off gas supply to dryer.
3.
Perform the procedures on page 4-4, “Removing the
Top Panel” and “Removing the Console/UI” prior to
performing the following steps.
4.
Perform the procedures on page 4-6, “Removing the Front
Panel” prior to performing the following steps.
Gas Burner Assembly
Figure 1
5.
Remove the ignitor from the burner (see page 4-13 for the
procedure).
6.
Disconnect the 2-wire and 3-wire connectors from the
burner coil assembly terminals (see Figure 3).
7.
Remove the two screws from the burner support bracket
and remove the bracket from the burner (see Figure 3).
8.
Remove the two screws from the front of the burner
bracket and remove the burner assembly from the dryer.
Gas Burner Assembly
Figure 2
Coils w/Connectors
3-Wire
2-Wire
Support Bracket
Screws
Burner Bracket
Screws
Figure 3
9.
Remove the two screws from the coil retaining bracket.
Retaining Bracket Screws
Figure 4
10.
Lift the two coils off their cores and remove them.
Figure 5