FOR SERVICE TECHNICIAN’S USE ONLY
PART NO. W10156037A
TECH SHEET - DO NOT DISCARD
PAGE 10
Reinstalling the Electronic
Assemblies
Refer to preceding removal sections and replace in
reverse order.
NOTE:
When replacing the cycle selector switch,
make sure that the shaft is positioned through the
center of the shaft seal that is captive between the
decorative overlay and the console panel insert.
NOTE:
When reconnecting wire connections, be sure
to route the user interface wires beneath the retainer
clips on the user interface back cover.
REMOVING THE BACK PANEL
1.
Unplug dryer or disconnect power.
2.
Remove the cover plate screw and cover plate.
See figure 18.
3.
Remove the nine rear screws from the back
panel (for steam models remove the additional
screw near the valve opening at the bottom).
4.
Remove the panel.
Figure 18.
Remove screws.
Locking
Tabs
User Interface
Assembly
Cycle Selector
Switch
Figure 17.
Gently apply pressure to
locking tabs to release the user interface
assembly.
