Whirlpool WED4915EW1, Инструкция по использованию и уходу

Страница: 12 / 28

12
First try the solutions suggested here or visit our website at www.whirlpool.com/product_help -
In Canada www.whirlpool.ca for assistance and to possibly avoid a service call.
If you experience
Possible Causes
Solution
TROUBLESHOOTING cont.
Cycle time too short Automatic cycle ending early. The load may not be contacting the sensor strips. Level the
dryer.
Use Timed Dry for very small loads. Change the Dry Level
setting on ACCUDRY™/Automatic Dry cycles.
Increasing or decreasing the Dry Level setting will change the
amount of drying time in a cycle.
Lint on load Lint screen clogged. Lint screen should be cleaned before each load.
Stains on load or drum Dryer fabric softener not properly
used.
Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can stain
your garments.
Drum stains are caused by dyes in clothing (usually blue jeans).
These will not transfer to other clothing.
Loads are wrinkled Load not removed from dryer at the
end of the cycle.
Select Wrinkle Shield™ feature to tumble the load without heat
to avoid wrinkling.
Dryer tightly packed. Dry smaller loads that can tumble freely reduce wrinkles from
forming.
Odors You have recently been painting,
staining, or varnishing in the area
where your dryer is located.
If so, ventilate the area. When the odors or fumes are gone
from the area, rewash and dry the clothing.
The electric dryer is being used for
the first time.
The new electric heating element may have an odor. The odor
will be gone after the first cycle.
Load is too hot
Laundry items removed from the
dryer before the end of the cycle.
Allow Cool Down cycle to finish before removing laundry from
dryer. All cycles are cooled slowly to reduced wrinkling and
make it easier to handle. Items removed before Cool Down may
feel very warm.
A high temperature cycle was used,
or a separate temperature control
was set on high.
Select a lower temperature and use an automatic drying cycle.
These cycles sense the temperature or the moisture level in the
load and shut off when the load reaches the selected dryness.
This reduces overdrying.