Whirlpool WBA 3399 NFC IX, Инструкция по использованию и уходу

Страница: 5 / 36

5
EN
INTENDED USE
OF THE PRODUCT
This appliance is designed solely
for use as domestic usage. To aim
the appliance as professional use
is forbidden.
The manufacturer declines
allresponsibility for innapropiate
use or incorrect setting of the
controls.
The appliance is not intended to
be operated by means of an
external timer or separate remote
control system.
Do not use the appliance
outdoors.
The bulb used inside the
appliance is specifically designed
for domestic appliances and is
not suitable for general room
lighting within the home (EC
Regulation 244/2009).
INSTALLATION
Only activate the appliance when
the installation procedure has
been completed.
Installation and repairs must be
carried out by a qualified
technician, in compliance with
the manufacturer’s instructions
and local safety regulations. Do
not repair or replace any part of
the appliance unless specifically
stated in the user manual.
Use protective gloves to perform
all unpacking and installation
operations.
The appliance must be
disconnected from the power
supply before carrying out any
installation operation.
After unpacking the appliance,
make sure that it has not been
damaged during transport. In the
event of problems, contact the
dealer or your nearest After-sales
Service.
During installation, make sure the
appliance does not damage the
power cable.
The appliance must be handled
and installed by two or more
persons.
When installing the appliance
make sure that the four feet are
stable and resting on the floor,
adjusting them as required, and
check that the appliance is
perfectly level using a spirit level.
Remove the bottom protection
by tilting and turning the washing
machine on one rear bottom
corner. Make sure that the plastic
part of the bottom protection (if
available on the model) remains
in the packing and not in the
machine bottom. This is
important, as otherwise the
plastic part could damage the
washing machine during
operation.
Wait at least two hours before
switching the appliance on, to
ensure that the refrigerant circuit
is fully efficient.
Make sure the appliance is not
near a heat source.
ELECTRICAL WARNINGS
Make sure the voltage specified
on the rating plate corresponds
to that of your home.
The power supply ranges are
indicated on the rating plate.
Regulation require that the
appliance is earthed.
For installation to comply with
current safety regulations, an
omnipolar switch with minimum
contact gap of 3mm is required.
If the power cable is damaged it
must be replaced with an
identical one. The power cable
must only be replaced by a
qualified technician in compliance
with the manufacturer instruction
and current safety regulations.
Contact an authorized service
center.
The electrical components must
not be accessible to the user after
installation.
The power cable must be long
enough for connecting the
appliance, once fitted in its
housing, to the main power
supply.
Do not use extension leads.
Do not pull the power supply
cable.
Do not use multiple plug
adaptors if the appliance is fitted
with a plug.
For appliances with fitted plug, if
the plug is not suitable for you
socket outlet, contact a qualified
technician.
Do not touch the appliance with
any wet part of the body and do
not operate it when barefoot.
Do not operate this appliance if it
has a damaged mains cord or
plug, if it is not working properly,
or if it has been damaged or
dropped. Do not immerse the
mains cord or plug in water. Keep
the cord away from hot surfaces.
When using a residual current
circuit breaker (RCCB), only use a
model marked with .