9
Install Bracket Assembly
1. Measure the width of the window opening and mark the
center line on the outside windowsill.
2. Measure and mark a line 12
⁹⁄₁₆
" on each side of the center
line.
3. Place the bracket assembly in the window. Check to see if
the bracket assembly matches the wall construction.
4. Using the leveling leg, adjust the angle of the bracket
assembly to a downward slope no more than
³⁄₁₆
" to allow
condensation to flow away from the window.
5. If necessary, remove the 1
¹⁄₂
" bolt, locking washer and
¹⁄₄
"
nut, and move the support bracket to the correct holes on the
mounting bracket to match the wall construction. Reinsert
the 1
¹⁄₂
" bolt, locking washer and
¹⁄₄
" nut.
6. Tighten
¹⁄₄
" nut with a
¹⁄₄
" wrench.
7. Align the V-slot with the lines marked in Step 2.
8. Use
¹⁄₈
" drill bit to drill starter holes for each of the two
bracket assemblies.
9. Using
³⁄₄
" screws, attach each bracket assembly to the
windowsill.
Attach Adhesive Seal
1. Cut the adhesive seal to the width of the lower window sash.
2. Remove the backing from the seal and attach the seal to the
bottom of the lower window sash.
Window Installation—Position the Cabinet
NOTES:
■
Handle the air conditioner gently.
■
Be sure your air conditioner cabinet does not fall out of the
opening during installation or removal.
■
The location where the power cord exits the air conditioner
should be no more than 4 ft (122 cm) from a grounded
3 prong outlet.
■
Do not block the louvers on the front panel.
■
Do not block the louvers on the outside of the air conditioner.
1. Center the empty cabinet in the window. Check that the
bottom curtain guide on the air conditioner cabinet is inside
the track provided by the bracket assemblies. Maintain a firm
hold on the air conditioner cabinet. Lower the window sash
behind the top channel.
A. Width of window opening
B. Center line
B
A
A. V-slots
B. 12
⁹⁄₁₆
from center line
A
B
B
