Whirlpool IC13B, Инструкция по установке и эксплуатации

Страница: 7 / 40

7
Installing Your Ice Maker
How to Mount the Ice Maker Kit
1
Screw
5
/
8
" ice maker mounting screws into
holes provided in
left wall of freezer
section.
• Leave head out
approximately
3 /
8
" for the slot in
the icemaker
hanger to slip over the screws.
• Remove phillips screw (A) if present
and discard.
2 Snap ice maker cover into place onto ice
maker.
• Insert tabs on top
of cover into slots
on top of end of ice
maker.
• Snap bottom of ice
maker ice maker cover into place.
4 Slip fill tube into self-
positioning fill tube opening
in back of ice maker..
3
Insert wire harness plug into
connector on back wall of freezer
by using a rocking motion until
locking fingers on plug snap
into place.
A
3
/
8
"
3 /
8
"
5
Slide ice maker
hangers (A) over
screws.
A
6
Insert remaining mounting
screw into bottom of ice
maker, and tighten down all
mounting screws.
7
Raise feeler arm to the
STOP (up)
position until water
connection is complete.
• Ice maker should feel securely mounted.
Replace baskets and shelves, and place ice
storage bin directly under ice maker.
8
NOTE:
Check again to make sure the icemaker wire
harness is fully inserted into its outlet.