7
PRIOR TO CONNECTING
MOUNTING THE APPLIANCE
INSTALLATION
A
fter
unpAcking
the
AppliAnce
, make sure that it has
not been damaged during transport and that the
appliance door closes properly.
i
n
the
event
of
problems
, contact the dealer or the
nearest After-sales Service.
f
ollow
The
supplieD
separaTe
mounTing
insTrucTions
when installing the appliance.
c
heck
ThaT
The
volTage
on the rating plate
corresponds to the voltage in the home.
D
o
noT
remove
the microwave inlet protection
plates located on the side of the microwave
oven cavity wall. They prevent grease & food
particles from entering the microwave inlet
channels.
e
nsure
The
microwave
oven cavity is empty before
mounting.
e
nsure
ThaT
The
appliance
is
noT
DamageD
.
Check
that the microwave oven door closes firmly
against the door support and that the internal
door seal is not damaged. Empty the microwave
oven and clean the interior with a soft, damp
cloth.
D
o
noT
operaTe
this appliance if it has a damaged
mains cord, if it is not working properly, or if it
has been damaged or dropped. Do not immerse
the mains cord in water. Keep the cord away
from hot surfaces. Electrical shock, fire or other
hazards may result.
i
f
The
power
cable
is too short, ask a qualified
electrician to install a socket close to the
appliance.
T
he
power
supply
corD
must be long enough for
connecting the appliance, once fitting in its
housing, to the main power supply.
f
or
insTallaTion
to comply with current safety
regulations, an omnipolar switch with
minimum contact gap of 3 mm must be utilized.
AFTER CONNECTING
T
he
appliance
can be operated only if the
microwave oven door is firmly closed.
T
he
earThing
of
This
appliance
is
compulsory
.
The
manufacturer will accept no responsibility for
injury to persons, animals or damage to objects
arising from the non-observance of this
requirement.
t
o
prevent
Any
dAmAge
, only remove the appliance
from its polystyrene foam base at the time of
installation.
c
hildren
should
not
perform
instAllAtion
operAtions
.
Keep children away during installation of the
appliance. Keep the packaging materials (plastic
bags, polystyrene parts, etc.) out of reach of children,
during and after the installation of the appliance.
T
he
manufacTurers
are not liable for any
problems caused by the user’s failure to observe
these instructions.
a
fTer
insTallaTion
,
the bottom of the appliance
must no longer be accessible. For correct
appliance operation, do not obstruct the
minimum gap between the worktop and the
upper edge of the oven.
