6
INSTALLATION
Technical information for the installer
After removing the oven from its packaging, before making the
connections place it on the polystyrene foam base to protect it
from damage.
Oven installation requires two people. Do not attempt to lift the
oven by the door handle. Lift by means of the handles on the side
of the oven.
Check that the appliance has not been damaged in transit.
Oven dimensions and kitchen unit dimensions are shown in the
figure opposite.
Any adjacent kitchen units must be heat resistant (80° C min).
If plastic laminates or cement are not sufficiently heat-resistant,
warping, bubbling or detachment of the finish may result.
Install the oven in the housing, lifting it by the sides, taking care
not to trap the wires of the power supply cable.
For correct ventilation, observe the ventilation opening
directions shown in the figure (500 min x 80 mm and 500
min x 50 mm inside the cabinet).
Secure the oven to the kitchen unit with screws (A) as shown.
During oven installation, care must be taken to ensure that the
sides do not touch the front edges of the housing or adjacent
drawers and doors (see picture).
•
Important: do not connect to the power supply until
you have finished connecting the oven and cooktop.
•
Make sure the appliance is installed and connected to
the power supply by a qualified technician in
accordance with the manufacturer’s instructions and
in compliance with local regulations.
•
The installer is responsible for the correct electrical
connection of the appliances and the observance of
the relative safety recommendations.
•
The appliance must be connected to the power supply
by means of an all-pole disconnect switch with
minimum contact gap of 3 mm.
•
The law requires that the appliance be earthed.
•
Do not use multiple plug adapters or extension leads.
•
After the oven has been installed, the electrical
components must be concealed.
Make sure that the voltage shown on the rating plate is
the same as the domestic power supply voltage.
The rating plate is on the front edge of the oven cavity
(visible with oven door open).
For Australia only:
The oven is delivered without supply cord. Use a supply cord
type H05 RR-F, 3X2,5 mm
2
min.
Fumes
vent
Earth
31002015GB.fm Page 6 Friday, November 21, 2008 5:39 AM
