GB -5-
Switch off the appliance Everything o.k. ...
Wash cycle
Select programme
Quick, permanent or alternating
6
7
8
Exercise caution when opening the door: beware of hot steam.
Only press the button
once to turn the appliance into Standby mode.
All the indicator lamps switch off. Unload the appliance, starting from the lower rack in order to avoid any residual drips of water falling onto crockery below.
Maintenance and care
Maintenance and care
Overview of programmes
The max. possible number of programmes is illustrated in the chapter “Chart”. The corresponding programmes for your appliance can be found on the panel (page 1).
Choose programme according to the attached table of programmes (page 1).
Duration of the programme depends on the external conditions in the apartment, temperature and pressure etc.
The dishwasher door must be closed and the water tap open.
To pause the programme (e.g. if you want to insert an item):
- Open the door with caution (the programme pauses) and insert
the item/s,
(beware of HOT steam!).
- Close the door and press the START button again to restart the
cycle (the programme resumes the cycle from where it was
interrupted).
To Cancel the programme on running:
- Press the button
.
- (Water drains for up to 30 seconds then
the appliance switches off).
To change the programme in progress:
- Press the button
to cancel the programme on running.
- (Water drains for up to 30 seconds then the appliance switches off).
- Press any button to switch on the appliance.
- Select a new programme.
- Press the START button.
Rectifying minor faults yourself ...
10
9
Filters
Check and
clean if
necessary
Unscrew filter
cylinder, remove it
and fine sieve...
Rinse under running
water ...
Screw on filter cylinder NOTE MARK!
Unscrew
and remove
upper arm ...
Spray arms
Remove
blockages/
deposits.
Insert
Clean spray
nozzles under
running water
(use toothpicks
if necessary) ...
Insert and screw on lower and upper arms tightly.
Unscrew
and remove
lower arm ...
