2
3
Unpack the refrigerator
• Remove all packaging materials (included foundation
pad, foam pad and gummed paper in the fridge)
before use.
• Clean both inside and outside of the fridge before use.
Use a humid rag and a mild detergent in warm water
for cleaning. Make sure to use clean water for the final
clean up.
• Make sure a separated dipolar earthed socket serving
only your refrigerator. It shall not share with any other
electrical equipment.
• Connect the earth wire well, the earthed polar of the
socket shall have reliable earthing wire.
Transportation
• Do not turn over, put across, extrude or shock the
fridge, the angle of bank cannot be over 45 degree.
• Do not make door or coping over strained to avoid
distortion.
• The fridge can be slightly lean back (no more than 20
degree) to make short distance move by the rolling of
back castor.
• When moving the refrigerator (horizontally or tilted),
more than 2 persons are required to hold it. (One to
hold top back handles, the other to hold the bottom
holder. ) If other parts are held instead, it is very
dangerous and likely to slip.
• Be sure to turn up the wheel first before moving the
refrigerator. The wheels can damage or scratch the
floor.
• If you are moving it for a long distance, never forget to
fasten the interior parts tightly with tapes. Otherwise,
the parts can collide and break each other.
Placement
• The fridge shall be placed in the well ventilated place.
Far away from moist place or place there is water to
avoid rusting or weaken the insulation effect.
• The headroom of the fridge shall no less than 30cm,
the distance from the two sides and the back to the
wall shall no less than 10cm, to the convenience of
open and close the door and heat emission.
• The fridge shall be placed on the plat and hard ground
(if uneven, it can be adjusted by the leveling legs).
Installation Guide
Read these safety instructions carefully before use and
follow precautions for your safety.
Precautions in installation and power
connection
To prevent fire, electric shock or leakage
1. Never install the refrigerator on a wet floor or where
water can gather easily.
2. Check the following before power connection.
- Connect power plug only to a grounded wall socket
(an earthed mains).
- Do not plug refrigerator power together with other
appliances to the same socket.
3. Do not use an adapter plug or an extension cord.
4. Do not let the power cord be crushed by other (heavy)
objects.
• If you hear a strange noise, strong chemical odour
or find smoke etc. from the refrigerator after the
power is plugged in, pull out the plug immediately
and call the service agent.
• Wait about 5 minutes before you plug-in again in
order to prevent any damage to the compressor and
electrical devices of refrigerator.
• Wait 2~3 hours until the inside gets cold enough
after the first power plug-in, then store foods inside.
(There can be some smell of plastic parts on initial
operation of the refrigerator after plugging in. The
smell fades away as the refrigerator works and
doors are opened and closed.)
Precautions in use
To prevent personal injury, fire, electric shock, etc. read
this user guide carefully before use and keep it at hand
for any reference.
Refrigerator Preparation
X603-13(영)_9S22FNI_IX(월풀).indd 2
2017-01-10 오후 1:52:46
