Whirlpool 809, Инструкция по технике безопасности

Страница: 4 / 10

GB14
Warning! Before carrying out any cleaning or maintenance operations disconnect the hood from the power supply by removing the plug from the socket, or
switching the general house mains switch off.
GREASE FILTER MAINTENANCE
The filter traps all cooking grease particles.
Wash the metal grease filter once a month (or when the filter dirty notification system indicates that the filter needs washing). The filter must be washed using
a soft detergent. It may be hand washed, or placed in the dishwasher on a short low temperature cycle.
Note: If washed in the dishwasher, the colour of the metal grease filter may fade. This will have no effect on its performance.
Remove the grease filter - Fig. 2
Remove the grease filter by rotating the knobs (g) that secure the filter to the hood 90°. Pull downwards.
To refit the grease filter follow the inverse procedure.
CARBON FILTER MAINTENANCE
The carbon filter traps unpleasant cooking smells.
Differently from traditional carbon filters, this type of carbon filter may be cleaned and reactivated.
With normal use of the hood, the filter should be washed once a month. The best way to wash the carbon
filter is by placing it in the dishwasher at the highest temperature, using a standard dishwasher
detergent. To avoid any food or dirt particle to get trapped in the filter during washing, causing bad
smells after, we recommend that the filter is washed on its own. After washing, the carbon filter must be
reactivated: place it in the oven at a temperature of 100°C for 10 minutes.
The filter will keep its capacity to absorb smells for three years, after which time it must be replaced.
FITTING THE CARBON FILTER* -Fig. 3
Remove the grease filter.
Position the carbon filter pad around the grease filter, securing it using the appropriate securing devices.
Fit the upper cap and secure using the locking spring.
Refit the grease filter with the carbon filter inside the hood.
To remove follow the inverse procedure.
REPLACING THE LAMPS - Fig. 4
Disconnect the hood from the electric power supply.
- Replace the damaged lamp. (Fig.4)
- Only use 20W max - GU4 - 12V - Ø 35mm - 30° - Dichroic halogen lamps, making sure not to touch
them.
Important: make sure you don't touch the lamp with your hands.
- Before performing this operation disconnect the
hood from the electric power supply.
If the lamps do not work, before contacting customer care ensure that they are fitted correctly.
WARNING:
MAINTENANCE