Whirlpool 6ADP2956 IXM - SERVICE, Руководство по обслуживанию

Страница: 15 / 19

WHIRLPOOL CONSUMER SERVICES
Model 6ADP2956 IXM
Page 15 of 19
5. After completion of any repair, run the test programme again to confirm repairs have
been effective.
NOTE 1 : The first step with test programme of new service control boards is without any
backrinsing steps. This is to prevent the machine from overflowing if it contains
any water at the start of the test. The second run of the test programme will
include the backrinsing steps.
NOTE 2 : Indicated failures F1 : NTC failure
F2 : Water leakage
F9 : Continuous water inlet
will cause the diagnostic programme to terminate, so these failures must be
repaired before it is possible to complete the test.
Once a wash programme has been started it cannot be altered but must be cancelled by
holding the start button for more than three seconds.
As the components are controlled by electronic devices, meaningful output voltage
measurements from the control board can only be made with the component connected. Do
not attempt to measure open circuit voltage output from the control board.
PASSIVE TEST PROGRAMME
Passive test programme will indicate the mode of
Start failure. If there is no failure, the test programme
will result in the four programme progress lights in
the display panel flashing sequentially.
Starting the Passive Test Programme
Four programme 1. Turn the programme selector to the off ("O")
progress lights position
flash sequentially
2. Push and hold the start button while turning the
programme selector to the first cycle (40°C-55°C
Normal) until the start button light begins to flash.
Chosen programme
LED lights
3. Release the start button.
4. The start button light will flash in a sequence to
indicate the mode of failure. (See table on
Page 14)
Finish passive test
programme by starting 5. Repair failure.
active test programme
6. Reset programme by pressing the start button for
more than 3 seconds.
7. Start passive test again and progress to active
test by pressing the start button for less than 3
seconds