Check location where washer will be
installed. Proper installation is your
responsibility. Make sure you have
everything necessary for correct
installation.
No. T20 Torx
screws
Coin-operated washers are equipped
with a meter case, console, timer,
selector switches and indicator lights.
The coin slide mechanism, slide
mounting bolt, slide extension, service
door panel lock and key, top lock
and key, coin vault, and coin vault
lock and key are not included with
this washer and are needed to
complete installation. These items are
available from usual industry sources.
Hot and cold water faucets
must be
within 4 feet of the back of the
washer and provide water pressure
10-100 PSI. A pressure reduction valve
should be used in the supply line
where inlet pressure entering the
building exceeds 100 PSI to prevent
damage to the washer mixing valve.
Grounded
electrical outlet
is required. See
Electrical
requirements.
Single washer
installations require
12” minimum risers
to provide an air
cushion and
prevent noise and
damage to valves.
Untape and
open washer
lid. Remove
packages and
hoses from
washer.
Water heater:
Set
to deliver 140°F to
160°F water to the
washer.
Standpipe drain system:
Needs a two-
inch minimum carry-away capacity
of 17 gallons per minute. Top of
standpipe must be at least 34 inches
high and no higher than 72 inches
from bottom of washer.
Level floor:
Maximum slope
under washer — 1 inch
On coin-operated washers, front
access to the pump area is available
by removing the two, No. 10 Torx
screws and then removing the front
panel. Non-coin-operated washers
do not have a removable front panel.
The cabinet and top assembly must
be removed by removing clips under
console on the non-coin-operated
washer.
Support:
Floor must be sturdy enough
to support loaded washer weight of
315 pounds.
A floor drain
should be provided
under the bulkhead. Prefabricated
bulkheads with electrical outlets,
water supply lines and drain facilities
should be used only where local
codes permit.
Non-coin-operated washers are
equipped with a console, push to
start timer, selector switches and
indicator lights (not pictured).
Important: Observe all governing
codes and ordinances.
PAGE 2
Your safety and the safety of
others is very important.
We have provided many important
safety messages in this manual and on
your appliance. Always read and obey all
safety messages.
This is the safety alert
symbol. This symbol alerts
you to hazards that can kill or
hurt you and others. All safety
messages will be preceded by the safety
alert symbol and the word “DANGER” or
“WARNING”. These words mean:
All safety messages will identify the hazard,
tell you how to reduce the chance of injury,
and tell you what can happen if the
instructions are not followed.
You will be killed or seriously injured if
you don’t follow instructions.
You can be killed or seriously injured if
you don’t follow instructions.
DANGER
WARNING
Do Not store or operate washer below
32°F some water may remain in
washer).
See Use & Care Guide for
“Winterizing” information.
Before you start...
