Whirlpool 2318587 Скачать руководство пользователя страница 7

Страница: 7 / 48

WATER BOTTLE MODE:
You can dispense water by typical water bottle volumes in
ounces or liters. To dispense a volume not listed in the table
below, you must use Custom mode.

3. Press UNITS to select your desired setting.
4. Press the PLUS (+) and MINUS (-) buttons to adjust the

volume as desired.
NOTE: Most coffee cups (commonly 4 to 6 oz [118 to 177 mL]
per cup) are not the same size as a measuring cup
(8 oz [237 mL]). You may need to adjust the volume to avoid
unintentionally overfilling coffee cups.

5. To dispense water, press a sturdy glass against the water

dispenser pad OR place the glass below the water dispenser
and press the WATER button.
NOTE: While dispensing water, the digital display will count
down how much water remains to be dispensed, according to
the volume you selected. The flow of water will automatically
stop once the desired volume has been dispensed.

6. To stop dispensing before the selected volume has been

dispensed, remove the glass from the dispenser pad OR press
the WATER button a second time.
NOTE: If you stop dispensing before the desired volume has
been dispensed, the digital display will continue to show how
much water remains to be dispensed. The display will turn off
after one minute of inactivity.

To select a new volume or select the same volume again, you
must first finish dispensing the selected volume, or turn the
Measured Fill feature off and then turn it back on.

Rotating Faucet and Pull-out Tray (on some models)

Your dispenser may include a rotating water faucet and a small
pull-out tray at the bottom of the dispenser.

■

The faucet rotates up to 180° to allow for easy dispensing into
large containers. Rotate it by pressing PUSH HERE, located
on the right-hand side of the faucet as shown.

NOTE: When using the dispenser with the faucet rotated, do
not use the water dispenser pad. Only use the WATER button
to dispense. Dispensing by pressing the container against the
water dispenser pad may result in unintentional spilling.

■

The tray can be pulled out approximately 2" (5.08 cm) to
better support large containers. It is designed to catch small
spills and allow for easy cleaning. There is no drain in the tray.

NOTE: The tray can be removed from the dispenser and
carried to the sink to be emptied or cleaned. Pull the tray out
until it hits the stop, then gently lift up on the back of the tray
and slide it out the rest of the way.

The Ice Dispenser

Ice dispenses from the ice maker storage bin in the freezer when
the dispenser pad is pressed. The dispensing system will not
operate when the freezer door is open. To turn off the ice maker,
see “Ice Maker & Storage Bin.”
Before dispensing ice, select which type of ice you prefer by
pressing the CUBED or CRUSHED button. For crushed ice, cubes
are crushed before being dispensed. This may cause a slight
delay when dispensing crushed ice. Noise from the ice crusher is
normal, and pieces of ice may vary in size. When changing from
crushed to cubed, a few ounces of crushed ice will be dispensed
along with the first cubes.

To Dispense Ice:

1. If the ice storage bin is located on the door, remove the

temporary shield from underneath the ice storage bin. See
“Ice Maker and Storage Bin.”

2. Press the button to select the desired type of ice.

3. Press a sturdy glass against the ice dispenser pad. Hold the

glass close to the dispenser opening so ice does not fall
outside of the glass.
IMPORTANT: You do not need to apply a lot of pressure to the
pad in order to activate the ice dispenser. Pressing hard will
not make the ice dispense faster or in greater quantities.

4. Remove the glass to stop dispensing.

NOTE: Ice may continue to dispense for up to 10 seconds
after removing the glass from the pad. The dispenser may
continue to make noise for a few seconds after dispensing.

The Dispenser Light (on some models)

When you use the dispenser, the light will automatically turn on.
If you want the light to be on continuously, you may choose either
ON or NIGHT LIGHT.

ON: Press LIGHT to turn the dispenser light on.
NIGHT LIGHT: Press LIGHT a second time to select the Night
Light. The dispenser light will automatically adjust to become
brighter as the room brightens, dimmer as the room darkens.
OFF: Press LIGHT a third time to turn the dispenser light off.
The dispenser lights are LEDs that can not be changed. If it
appears that your dispenser lights are not working, be sure that
the light sensor is not blocked (in Night Light mode). See
“Troubleshooting” for more information.

The Dispenser Lock (on some models)

Your dispenser can be turned off for easy cleaning or to prevent
unintentional dispensing by small children and pets.
NOTE: The lock feature does not shut off power to the product, to
the ice maker, or to the dispenser light. It simply deactivates the
ice and water dispensers. To turn off the ice maker, see “Ice
Maker & Storage Bin.”

■

Press and hold LOCKOUT for 3 seconds to lock the
dispenser.

■

Press and hold LOCKOUT a second time to unlock the
dispenser.

Units

Pre-set Volumes

Ounces

16, 20, 24, 33

Liters

0.5, 0.6, 0.75, 1.0

A. Faucet rotated 180°
B. Pull-out tray

Cut Hazard