12
TROUBLESHOOTING
You can solve many common air conditioner problems easily,
saving you the cost of a service call. Try the suggestions below to
see whether you can solve your problem without outside help.
Air conditioner will not operate.
■
The power supply cord is unplugged. Firmly plug the power
supply cord into a properly grounded 3 prong outlet with
proper voltage. See “Electrical Requirements.”
■
A household fuse has blown or circuit breaker has
tripped. Replace the fuse or reset the circuit breaker. Make
sure the air conditioner is plugged into a properly grounded
3 prong outlet. See “Electrical Requirements.”
■
The Power button has not been pressed. Press the
POWER button.
■
The local power has failed. Wait for power to be restored.
Air conditioner blows fuses or trips circuit breakers.
■
Too many appliances are being used on the same circuit.
Unplug or relocate appliances that share the same circuit.
■
Time-delay fuse or circuit breaker of the wrong capacity
is being used. Replace with a time-delay fuse or circuit
breaker of the correct capacity. See “Electrical
Requirements.”
■
An extension cord is being used. Do not use an extension
cord with this or any other appliance.
■
You are trying to restart the air conditioner too soon after
turning off the unit. Wait at least 3 minutes after turning off
the unit before trying to restart the air conditioner.
Air conditioner seems to run too much.
■
The current air conditioner replaced an older model. The
use of more efficient components may cause the air
conditioner to run longer than an older model, but the total
energy consumption will be less. Newer air conditioners do
not emit the “blast” of cold air you may be accustomed to
from older units, but this is not an indication of lesser cooling
capacity or efficiency. Refer to the efficiency rating (EER) and
capacity rating (in BTUs/hr.) marked on the air conditioner.
■
The air conditioner is in a heavily occupied room, or heat-
producing appliances are in use in the room. Use exhaust
vent fans while cooking or bathing and try not to use heat-
producing appliances during the hottest part of the day. A
higher capacity air conditioner may be required, depending
on the size of the room being cooled.
Air conditioner cycles on and off too much.
■
The MODE is set to POWER SAVER. Use Power Saver only
when you are away from home or asleep. Use COOL and a
higher fan setting for your best comfort.
■
The air conditioner is not properly sized for your room.
Check the cooling capabilities of your room air conditioner.
Room air conditioners are not designed to cool multiple
rooms.
■
The filter is dirty or obstructed by debris. Clean the filter.
■
There is excessive heat or moisture (open container
cooking, showers, etc.) in the room. Use a fan to exhaust
heat or moisture from the room. Try not to use heat-
producing appliances during the hottest part of the day.
■
The louvers are blocked. Install the air conditioner in a
location where the louvers are free from curtains, blinds,
furniture, etc.
■
The outside temperature is below 66°F (19°C). Do not try to
operate your air conditioner in the cooling mode when the
outside temperature is below 66°F (19°C).
■
The temperature of the room you are trying to cool is
extremely hot. Allow extra time for the air conditioner to cool
off a very hot room.
■
Windows or doors to the outside are open. Close all
windows and doors.
■
The Air Exchanger is set to OPEN (on some models). Set
the Exhaust control to CLOSED for maximum cooling and/or
heating.
■
Temperature control is not at a cool enough setting.
Adjust the TEMPERATURE control to a cooler setting. Press
the TEMP minus pad to reduce the temperature by 1º until it
reaches 66ºF (19ºC). Set the FAN SPEED control to TURBO.
■
The air conditioner is installed on the sunny side of your
house. Install your air conditioner in a more shaded window.
Water drips from cabinet into your house.
■
The air conditioner is not properly leveled. The air
conditioner should slope slightly downward toward the
outside. Tilt the air conditioner to a downward slope to the
outside to ensure proper drainage. See the Installation
Instructions. Reposition or shim the cabinet as necessary.
NOTE: Do not drill a hole in the bottom of the metal base and
condensate pan.
Air conditioner cooling, but room is too warm -
Ice
forming on cooling coil behind intake grille.
■
The outside temperature is below 66°F (19°C). Do not try
to operate your air conditioner in the cooling mode when the
outside temperature is below 66°F (19°C).
■
The filter is dirty or obstructed by debris. Clean the filter.
Содержание 1187617
Страница 15: ...15 Notes ...
