18
CAUTION!
TO PREVENT INJURY, ALWAYS TURN POWER OFF AND DISCONNECT THE OVEN’S POWER
CORD BEFORE PERFORMING SERVICE. VERIFY THAT UNIT IS COOL TO THE TOUCH.
Unplug oven, remove trays from inside, then lay oven on its side and remove screws from bottom and back covers .
Disconnect heater wires to pull thermocouple out from the muffle, then through the grommet into lower housing .
Disconnect thermocouple from the main board .
Note: Thermocouple should be wired as shown above. Heater wire must rest over ceramic
sheath not to come in contact with bare wire or fiber sleeve.
Front View Large
Rear Back View Medium
Rear View Medium
Rear Back View Large
Rear View Large
10
Screws
6 Screws Bottom Cover
Note: make sure to run thermocouple wire through loop
to hold wire stable before pulling into upper housing.
4 Screws Bottom Cover
FIELD SERVICE
For assistance call 1-800-626-5651 or write to: tops@whipmix .com
REPLACEMENT INSTRUCTIONS: 15295 JELRUS THERMOCOUPLE
Содержание P.D.Q.
Страница 1: ...115 and 230 volt Models P D Q Automatic Burnout Furnaces OPERATOR S MANUAL...
Страница 17: ...17 Figure 5 PDQ D WIRING DIAGRAM...
Страница 22: ...NOTES 22...
Страница 23: ...NOTES 23...