Page 4
WHE
LEN ENG . 81642
STROBE BULB ASSEMBLY
82773
DIE CAST BASE
NOTE POSITION
OF HOLES
LINE WIDE NOTCH IN STROBE BULB ASSEMBLY,
WITH ARROW ON CIRCUIT BOARD AND ALIGNMENT TAB ON DIE CAST BASE
UP
ALIGNMENT
TAB
ALIGNMENT
TA
B
68668
WIRE
SLOT
TWIST-IN
BULB
NOTE
POSITION
OF SCREWS
STROBE POWER SUPPLY ASSEMBLY
(
CIRCUIT SIDE UP)
CIRCUIT BOARD /
WIDE
NOTCH
NARROW
NOTCH
FUSE
BLACK WIRE, NEGATIVE (-)
RED WIRE, POSITIVE (+)
ON/OFF
SWITCH
FUSE
MODEL S360S STANDARD.
ON/OFF SWITCHING
FOR HIGH POWER
ONLY.
MODEL S360S STANDARD.
HIGH-OFF-LOW SWITCHING.
NOTE:
Cut Violet (looped) wire, run
it out of unit with black and red wires.
When the violet wire is grounded,
you are in the high mode and
when the violet wire is floating
you are in the low mode.
NOTE:
10 AMP
ALL SWITCHES AND FUSES ARE CUSTOMER SUPPLIED. USE
FUSE FOR 12 VDC OPERATION.
S W I T C H C O N T R O L W I R I N G S C H E M AT I C S F O R T H E S 3 6 0 S S T R O B E L I G H T
BLACK WIRE, NEGATIVE (-)
RED WIRE, POSITIVE (+)
RED WIRE, POSITIVE (+)
BLACK WIRE, NEGATIVE (-)
VIOLET WIRE, NEGATIVE (-) HI/LOW
DOUBLE POLE,
DOUBLE THROW
CENTER OFF SWITCH
(REAR VIEW)
+
+
WIRES TO POWER SOURCE
WIRES TO STROBE
LIGHT HEAD ASSEMBLY
WIRES TO POWER SOURCE
WIRES TO STROBE
LIGHT HEAD ASSEMBLY
FUSE
FUSE
S360S Disassembly Procedure
WARNING:
The Strobe Power Supply is a high voltage
device. Do not remove tubes or dismantle strobe light head
assembly while in operation. Wait 10 minutes after turning off
power before starting work or any trouble shooting.
IMPORTANT: Be sure to tape or remove any unused wires.
1.
Remove the clamp ring screw and the clamp ring.
2.
Remove the light bulb (Item 14) then carefully remove the
optic dome, the inner optic lens and upper reflector.
3.
Lift out the strobe tube assembly and unplug it.
4.
Remove the 3 screws holding the circuit board to the
base casting, and lift the circuit board off.
S360S Assembly Procedure:
1.
Feed the strobe wires out through the wire slot in the strobe
power supply assembly. Attach the power supply assembly
to the aluminum base using the 3 screws and lock washers.
IMPORTANT:
Be sure the alignment tab in the aluminum base
lines up with the arrow labeled “ALIGNMENT TAB” etched into
the circuit board and the
wider
of the 2 notches on the bulb
assembly.
2.
Connect the wires and place the strobe bulb assembly on
top of the base. (Be careful to line the wide notch in the
strobe bulb assembly up with the wire slot in the strobe
power supply assembly as shown below).
3.
Place the inner optic lens on top of the strobe and the upper
reflector on top of the optic lens.
4.
Attach the optic dome to the base with the clamp ring and
screw.
Be sure to position the clamp ring with the screw
facing the rear of the vehicle.
