Page 3
CUT VIOLET
WIRE HERE
RUN VIOLET WIRE OUT HERE
COMET FLASH
LEAVE
IN
TRIPLE FLASH
LEAVE
IN
DOUBLE FLASH
CUT
OUT
SINGLE FLASH
CUT
OUT
FLASH PATTERN
LEAVE
IN
CUT
OUT
LEAVE
IN
CUT
OUT
R27
RESISTOR
R26
RESISTOR
CometFlash:
Tripleflash:
DoubleFlash:
SingleFlash:
Is the default setting.
Leave R26 in and cut R27 out.
Cut R26 out and leave R27 in.
Cut both resistors out.
R26
R27
STROBE POWER SUPPLY ASSEMBLY
(
)
CIRCUIT BOARD / BOTTOM
RESISTORS
R26 & R27
RED
CUSTOMER
SUPPLIED
7.5 AMP FUSE
BLACK
VIOLET
SPST SWITCH
CLOSED:
OPEN:
HIGH POWER
LOW POWER
BATTERY
CUSTOMER
SUPPLIED
ON / OFF SWITCH
Hi/Lo Intensity Option:
1.
Take the dome and strobe power supply assembly apart
(See, “S360S Disassembly Procedure”).
2.
2.
Locate the VIOLET (looped) wire, cut it at pin 2, and run it
out of the bottom of the unit with the BLACK and RED wires.
3.
3.
Reassemble the unit.
4.
4.
Connecting the VIOLET wire to ground will cause the
S360S to operate in high power mode. Removing this wire
from ground forces the beacon into low power mode. A two-
position switch can be installed so that the operator can
easily alternate between high and low power operation (see
Switch Control Wiring Schematics Chart).
Flash Pattern Options:
The S360S comes set in its default setting (Comet Flash). You
may choose from several other options (Single Flash, Double
Flash and Triple Flash) by either cutting out or leaving in one or
both of the resistors located on the circuit board.
1.
First take the unit apart as described under “S360S
Disassembly Procedure”, to get to the circuit board.
2.
Now using the diagram below, find the 2 resistors on the
circuit board. Use the chart below to engage whichever flash
pattern you choose.
