Page 3
EDG
E 90
00
EDGE
9000
ED
EDGE
9000
EDGE
9000
Fig. 5
LENS SPACER
COVER SEAL
MATRIX BOARD
21. Now examine the heat sink
on your power supply. If it
is the same as the heat
sink shown in Fig.3, it must
be removed and replaced
with the heat sink included
with this kit. If the existing
heat sink is the same as
the one included with this
kit, do not replace it.
22. Using the long stand-offs and the internal-tooth lock
washers included with this kit, remount the power
supply in the extrusion (Fig. 4). Do not allow any harness
wires to be pinched between the power supply and the
extrusion!
23. Slide the lens spacer (included) shown in Fig. 5, into the
bottom lens channel of the extrusion. Position this spacer
directly in front of the power supply.
24. Slide the cover seal (included) into the upper lens
channel of the extrusion. Position this seal directly in front
of the power supply.
25. Plug the PierceAlert™ into the two-conductor that was
installed earlier (either connected to the matrix board or
routed into the vehicle).
26. Return all lenses and dividers to their original locations.
27. Position the PierceAlert in front of the power supply.
Insert the alignment tabs into both the upper and lower
lens channels. Be sure the lenses on either end of the
PierceAlert are behind the PierceAlert housing (Fig. 6).
28. Secure the PierceAlert to the power supply stand-offs
with the supplied Phillips-head screws.
Do not tighten
these screws yet!
29. Install the endcaps on the extrusion and tighten all of the
endcap mounting screws.
30. Tighten the PierceAlert mounting screws firmly.
Fig. 4
STAND-OFF
(LONG)
INTERNAL TOOTH
LOCK WASHER
Fig. 6
EXTRUSION
INPUT CABLE
Fig. 3
