Page 6 of 9
7. Carefully
pull
the
protective backing tabs
out from under the
FastTrax
housing.
Make sure that the
housing’s position is not
disturbed during this
process.
8. With
all
of
the
protective
backing
strips removed, press
down firmly along the
edges of the housing to
promote adhesion.
WARNING!The vehicle should not be driven for a minimum of 24 hours after
installation. The adhesive used in this procedure must remain at
65°F
(minimum)
for 24 hours
after installation. Caution should be used if the vehicle must be driven
between 24 and 72 hours after installation. The adhesive should be fully bonded
after 72 hours.
Mounting the FastTrax™ Control Head...
1. Locate a suitable mounting location for the control head. Be sure that the control head fits
properly and does not interfere with any dashboard components.
WARNING!
If the vehicle is equipped with air bags, do not mount the control head
within the “air bag deployment zone(s)” indicated in the vehicle owner’s manual. Fail-
ure to heed this warning could impair the air bag’s ability to function properly which
could, in the event of deployment, result in serious injury or death!
2. Position the control head on the proposed mounting location. Using a pencil or other suitable
tool, scribe the mounting surface where the holes are to be drilled.
CAUTION!
As mounting the control head will require drilling, it is absolutely necessary
to make sure that no vehicle components could be damaged by the mounting process.
Check both sides of the mounting surface before starting and if damage is possible,
select a different mounting location.
3. Drill the 2 mounting screw holes.
4. Position the control head onto the mounting surface.
Using the provided sheet metal screws, secure the
control head to the mounting surface.
5. Route the 9-conductor control harness and the
modular Diagnostix cable from the control head to
the power supply. These cables may be plugged
into the control head, but do not plug them into the
power supply at this time.
6. Locate the AMP 9-conductor pin housing. Cut and
remove the locking tabs from this housing as shown.
7. Using this illustration, insert the pinned wires on the
control harness into their proper location in the pin
housingand plug this cable into its port on the power
supply.
3
2
1
4
5
6
7
8
9
Pin 1
Brown
Pin 2
White/Black
Pin 3
Orange
Pin 4
Yellow
Pin 5
Green
Pin 6
Blue
Pin 7
Violet
Pin 8
Grey
Pin 9
White
Locking
Tab
(BOTTOM VIEW)
Protective
Backing
Cut
Protective
Backing
Here
(Do Not Cut
The Tape)