Page 3
LENS SHIELD
LENS SHIELD
HALOGEN BULB
WARNING:
P / N H20W12 (12V / 20 WATT)
DO NOT INSTALL
BULBS EXCEEDING 20 WATTS
DOME LENS
# 6 X 1
PPHSMS
WIRE
CLIPS
View #1
(Ref.)
1" X 2" VELCRO® STRIP
USED FOR DECK MOUNT
BASE
PAD
50 LB MAGNET
# 10 X 5/8"
PPHSMS
7' COIL CORD WITH
CIGAR PLUG (OPTIONAL)
PORTABLE
CIGAR PLUG
NORMAL / FAST SWITCH
or
ON / OFF SWITCH
(Optional)
P / N H35W24V (24 V / 35 WATT)
FOR 24 VOLT SYSTEMS ONLY
Wiring To Power:
1. Extend the RED and BLACK wires to the battery.
WARNING: All customer supplied wires that connect to the
positive terminal of the battery, must be sized to supply at
least 125% of the maximum operating current and fused
“at the battery” to carry that load.
2. Connect the BLACK wire directly to the vehicle’s chassis
ground (typically adjacent to the battery).
3. Connect the RED wire to one end of the user supplied fuse
block (3 amps). After the fuse block is in place, connect the
RED wire to the PO) terminal of the battery.
After this connection has been made, inspect the circuit wires
and make sure they are wired correctly. Replace the fuse if
blown with one of an identical amp. rating as the original. If the
fuse blows after installation or activation, contact Whelen
Engineering Technical Support.
Removing The Halogen Bulb:
1. Remove dome lens as shown in Fig. 1.
2. Locate the RED and BLACK wire connections on the back
side of the reflector. Disconnect the two wires by pulling
back on the wire clips shown in Fig. 3, View #1.
3. Bend the two lamp leads protruding from the reflector so
that they are straight, and remove the bulb.
4. When installing the new halogen bulb, follow these steps
above in the reversed order.
CAUTION:
Replacing any halogen bulb requires the use of
safety glasses to prevent injury. Do not handle the bulb with
bare hands. Use gloves to prevent possible injury.
WARNING!
The use of any Whelen magnetically mounted
warning light on a vehicle while it is in motion is at the sole
discretion and risk of the user and is not recommended.
REAR VIEW OF REFLECTOR
WIRE CLIPS
VIEW #1 (ENLARGED)
Fig. 3
The outer surfaces of this product may
be cleaned with mild soap and water.
Use of any other chemicals may void
the product warranty.
Do not use a pressure washer.
