Page 2
-
2
0
-
WHITE
/ YELLOW
NOT
USED
WHITE
/ GREEN
BROWN
GREY
RED
- 1
RED
- 2
ORANGE
WHITE
BLACK
- 1
BLACK
- 2
VIOLET
YELLOW
BLUE
- 1
BLUE
- 2
Installation:
Although technologically advanced, this unit is simple to install.
An aftermarket center console is recommended for the mounting
location. This not only allows the driver to reach the controls
easily, but also keeps the unit safely out of the path of the
vehicle’s SRS air-bag. Follow the console manufacturer’s
instructions for mounting information. If a console-type mount is
not possible, a bail strap mounting kit is included for over or under
dash mounting.
Connecting the Power & Ground Wires (Red & Black):
RED (Power) and BLACK (Ground)
1. Insert the wiring harnesses into it’s port as shown in Fig. 1.
2. Extend the 2 RED and 2 BLACK wires toward the firewall.
Follow the same path as the factory wire harness.
3. Continue to follow the factory harness through the firewall. To pass the RED and BLACK wires through, it may
be necessary to drill a hole in the firewall. If so, be absolutely sure that there are no components that could be
damaged by drilling. After the hole is drilled, insert a grommet to protect the wires.
WARNING:All customer supplied wires that connect to the positive terminal of the battery must be sized to
supply at least 125% of the maximum operating current and FUSED at the battery to carry that load. DO
NOT USE CIRCUIT BREAKERS WITH THIS
PRODUCT!
4. Route the RED and BLACK wires along the
factory harness towards the battery.
5. Install a 30 amp fuse block (15 amp for a
24 volt unit) (user supplied) on the end of
the RED wire.
Note: Remove the fuse from the fuse block
before connecting any wires to the battery!
6. Connect the fuse block wire to the
POSITIVE (+) terminal on the battery.
There must not be more than 2 ft. of wire
between the fuse block and the battery.
The wire between the fuse and the battery
is “unprotected”, do not allow this wire to
come in contact with any other wires.
7. Connect the BLACK wire to the factory
chassis ground, adjacent to the battery.
FIG. 1
READ BEFORE INSTALLING!!!
Do not install this product or route any wires in the
deployment area of your airbag. Equipment mounted
or located in the airbag deployment area will damage
or reduce the effectiveness of the airbag, or become
a projectile that could cause serious personal injury
or death. Refer to your vehicle owners manual for the
air bag deployment area.
The User/Installer assumes full responsibility to
determine proper mounting location, based on
providing ultimate safety to all passengers inside the
vehicle. Whelen Engineering Company assumes no
liability or responsibility for determining individual
applications or exact installation location criteria.
