P83879 D
Sheet 2 of 3
MOUNTING INFORMATION:
A
I
H
G
F
E
B
J
K
C
D
A. Centerline
B. Threaded mounting bosses
C. Mounting
tabs
D. Insert the (4) external mounting tabs into enclosure slots as
shown. Using enclosure assembly as template place against
mounting surface with centerline 80 inches above floormark
and drill (4) 1/4-inch diameter holes 1 inch deep.
E. (4) 10-12 x 1 inch plastic anchors
F.
(4) 10 x 1 1inch screws
G. (4) retaining clips
H. (4) 8-32 x 3/8-inch socket head screws.
I. Drain
screen
J. Neoprene
gasket
K. Cover (clear solid)
NOTE
: AFTER ALL INSTALLATION PROCEDURES HAVE BEEN
COMPLETED, INSTALL GASKET IN ENCLOSURE GROOVE NOW
PLACE COVER IN GROOVE AND POSITION THE FOUR (4) CLIPS
IN THE SLOT CLOSEST TO EDGE OF COVER. TIGHTEN THE
FOUR (4) 8-32 MACHINE SCREWS USING A 3/32 ALLEN
WRENCH.
4 IN SQUARE, FLUSH BACKBOX MOUNTING INSTRUCTIONS
GASKET
A
B
C
D
F
E
CENTERLINE
TOP VIEW
1-3/4"
CONDUIT ENTRY HOLE
MUST BE FIELD DRILLED.
1. DRILL A PILOT HOLE
(MAXIMUM 1/2")
1. Figure A is typical of a ¾ in. Rain tight conduit hub with neoprene o-ring threaded
for rigid conduit and imc. (O-Z/GEDNEY #CHM-75 or equivalent.)
2. Figure B is typical of a ¾ in. female adapter (Carlton #E942 or equivalent).
3. Figure C is typical of a ¾ in.-1/2 in. reduce bushing (Appleton #RB series or
equivalent).
4. Figure D is typical of a galvanized ½ in. conduit nipple.
5. Figure E is typical of a ½ in. conduit lock nut.
6. Figure F is typical of a 4 in. X 2-
⅛
in. Deep Square Backbox 9RACO190 or
equivalent).
STAND-OFF INSTALATION
INSTRUCTIONS FOR AREAS WITH
FREQUENT WASHDOWNS
STAND OFF BLOCKS (4)
EXTERNAL MOUNTING
TABS (4)
CLEANING INSTRUCTIONS FOR
ENCLOSURE AND COVER
1. Rinse with water to remove abrasive
dust and dirt.
2. Wash with soap or mild detergent, using
a soft cloth (do not scrub).
3. Rinse once more, than dry with a soft
cloth or chamois.
4. Rinse with water to remove abrasive
dust and dirt.
5. Wash with soap or mild detergent, using
a soft cloth (do not scrub).
6. Rinse once more, than dry with a soft
cloth or chamois.
To remove grease or wet paint, rub gently
with a cloth wetted thoroughly with naptha
then wash and rinse. DO NOT USE
RAZOR BLADES.
