Wheatstone Corporation VP-8IP, Техническое руководство

Страница: 109 / 240

page 4 – 35
VP-8IP / Sep 2013
V P - 8
i P
P R O G U I
Pro GUI Access
The system allows you to grant access at certain levels of permission in
order to control the privileges of those accessing the various features of the
VP‑8
iP
. Privileges are granted by the locked user Access Code, not by user type. In
fact, user types are created through the generation of access codes for those user types.
Examples:
• Suppose Access Code 0000 is created with Preset Takes being the only box checked.
This means that a person assigned access code 0000 can only take presets.
• Suppose Access Code 5678 is created with Preset Takes and Setting Changes both
checked. This means that a person with access code 5678 cannot only take presets,
but can also make changes to the settings within them. Note however that because
Preset Saves was not checked when this access code was created, that person may
make changes to a preset but may not save them!
Pro GUI Lock
In the event that security has been enabled by configuring the GUI Access Code &
Permissions Dialog (above), then selecting Pro GUI Lock will immediately lock the
Pro GUI on the host PC, prohibiting access until it has been unlocked with the proper
access code.
Unlocking the VP‑8
iP
Pro GUI when the passcode has been lost or forgotten:
The following instructions must be followed exactly as presented!
1. Re-install the PC Remote Pro GUI, but this time into a NEW folder on your
computer. DO NOT start up the Pro GUI yet!!
2. Make sure that the VP‑8
iP
is connected to your network or your computer and
that you know its HARDWARE IP address (you can use the command prompt
PING command to make sure that your computer can see the VP‑8
iP
). DO NOT
PROCEED if you do not have network connectivity to the VP‑8
iP
!