Wheatstone Corporation D-7, Техническое руководство, Страница: 32 / 92

M A S T E R P A N E L
page 4 – 3
D-7 / June 2006
Master SET Button
Like the SET button on the inputs, the master SET buttons are used to
access other controls and apply their settings to the master. The masters
may have their MODE settings changed and may be assigned to MUTE
MASTER A and/or MUTE MASTER B.
Channel Master ON/OFF
The ON switch turns the channel signal ON; pressing it again turns the
channel signal OFF. The switch LED lights to indicate the channel is ON.
Master Faders
These linear controls set the levels of the master channels.
NOTE that 5.1 MASTERS fader’s knob engraved with “5.1”.
AUX Talkback
Pressing the AUX 1 TALKBACK button will interrupt the AUX 1
output with the predefined TB signal. AUX 2 TALKBACK works in a
similar manner.
Sub-Mixes (Groups) Output
Generally the 4 audio submixes would operate in stereo mode. They may be
mixed to two duplicate mono channels by means of the channel SET button and
mode buttons in the MODE section of the EFS panel. The current mode will be
shown by the LED indicators in the MODE buttons.
Sub-Mix Talkback
Pressing the TB button will interrupt the group output with the
predefined TB signal.
Sub-Mix Destinations
To be effective, the surface outputs must be assigned to one or more
destinations, which are outputs from the Bridge Router System. Please
refer to the Bridge Router manual for details.
Sub-Mix Assign Buttons
These buttons are used to assign input channels to the groups. Press
SET on the input, then press any desired SUB-MIX ASSIGN button(s).
Assignment for the channel with its SET currently active are indicated by
the lighting of the four SUB-MIX ASSIGN buttons, while the SUB
displays on each channel show that channel’s group assignment whether
its SET is active or not.
Sub-Mix Assign to Master
Each group can be assigned to either of the two main stereo output
buses in the center section by using the eight ASSIGN buttons, which will
light to indicate assignment is made.