4
Assembly Instructions
1.
Unpack the unit and confirm that you have all the hardware and required parts.
2.
Remove the plastic caps from the hanger bolts of the Front Legs (C and D) for the following steps.
3.
Attach one Left Front Leg (C) to the Left front corner block of one Seat Frame (B) by inserting the
hanger bolts on the leg through the drilled holes on the corner block and fit the Flat Washer (5), Lock
Washer (4) and Hex Nut (3) onto each hanger bolt. Securely tighten the nuts with the provided open
wrench.
NOTE: DO NOT fully tighten all the nuts until the chair has been adjust and level all the legs so that they
do not wobble. Once adjusted, go back and tighten while making sure that the unit remains level.
4.
Insert the tenon of one Front Stretcher (G) into the mortise of the Left Front Leg (C). Make sure that the
slant holes on the stretcher will face the floor when the unit is turned upright.
5.
Repeat the same procedure to attach one Right Front Leg (D) to the right front corner block of the Seat
Frame (B). Be sure the mortise on Right Front Leg (D) fit onto the tenon of the Front Stretcher (G)
properly.
DO NOT fully tighten the bolts or nuts initially until all the bolts or nuts are
ready to assemble. To avoid causing damage to the thread, DO NOT over-tighten the nuts or bolts.
Hex Nut
(4 used in this step)
③
Lock Washer
(4 used in this step)
④
Flat Washer
(4 used in this step)
⑤