Whale Gusher 10 Mk3 BP3708, Инструкция по установке и эксплуатации

Страница: 5 / 8

This Whale Gusher® 10 is designed to only require minimal maintenance.
WARNING : Before servicing pump, drain water from system.
Inspection:
The diaphragms and inlet valves are held in place by the groove in the pump body and cover. Following inspection,
ensure that they are seated properly in the grooves before tightening the covers in place. Regular inspection of the
pump is recommended. Access to the pump chamber is quick and easy, requiring no tools. Rubber components
should be replaced if worn or every three years regardless of condition.
During periodic shipboard inspections, the bilge pump should be visually inspected to confirm parts are in good
condition, especially rubber parts and mounting arrangements. The pump should be operated to show that it pumps
water efficiently.
Annual Checks
• Whale advise that the boat's plumbing system is checked annually for leaks and obstructions.
Optimal Performance
• Ensure this product is clear of debris
It is recommended a service kit is kept on board. These are available from your local chandlery.
Changing the Diaphragm and Valves
1. Slacken and remove the wormdrive clip to release the diaphragm.
2. Release diaphragm nut and remove diaphragm plates and diaphragm.
3. Replace old inlet and outlet valves. Note: both inlet and outlet valves are same shape. The service kits
contain two sets of valves - round ones for the MK 2 pump and square valves for the MK 3 pump. DO NOT
mix the valve types!
4. Replace diaphragm and tighten wormclip in position and test for correct priming and discharge.
Fig. 8 Exploded diagram
8. MAINTENANCE
Body
Handle knob
Tolerance ring
Washer
Eye Bolt
Handle Tube
Lanyard
Buffer
Fork
Locknut
Washer
Bolt
Fulcrum brush and sleeve
Label
Clamping plate
Worm Drive Clip
Diaphragm
Nut
Bridge
piece
Screw
Bolt M6
Valve
Securing brush
Nut
Screw
Valve plate
Gasket
Bracket
Fork liner
Clamping plate
Fulcrum brush and sleeve
5