WFCO WF-9835, Руководство оператора

Страница: 6 / 18

6
INSTALLING THE DC (12 VOLT) SIDE OF THE CONVERTER. REFER TO FIGURE 1 ABOVE
5. Route the red wire from the converter up behind the mounting bracket for the fuse board
and connect it to the lug on the fuse board marked CONV POS.
6. Route the white wire from the converter to the fuse board and connect it to the lug on the
fuse board marked BATT NEG-.
7. Connect your wire coming from the battery positive to the lug on the fuse board marked
BATTERY POS+.
8. Connect your wire coming from the battery negative to the lug on the fuse board marked
BATT NEG-. NOTE: In some applications where the items in the RV are not grounded to
frame you may have to run an 8 AWG wire from the BATT NEG- lug on the fuse board out the
back of the housing and connect it to an additional bus bar (customer will have to purchase).
Then connect the wire from the battery negative and any negatives from the DC items to this
bus bar.
9. Attach the fuse board to the mounting bracket using the two screws provided.
10. Make sure you have the two 30-amp reverse polarity fuses in place and connect all the DC
output wire (as recorded) to the fuse board along with the correct fuse locations.
INSTALLING THE AC (110 VOLT) SIDE OF THE CONVERTER
11. Connect the neutral (white wire) from the converter to the neutral bus bar.
12. Connect the converter hot wire (black wire) from the converter to the breaker for the converter.
13. Connect the ground wire (green wire) from the converter to the ground bus bar.
14. Replace AC cover plate using the two screws provided.
15. Replace the door assembly using the screws provided.
16. Turn all breaker on and apply 110volt power to the RV. Test for operation.
TROUBLESHOOTING INSTRUCTIONS
Troubleshooting the WF-8900-AD-REP Series
Refer to the WF-9800-AD Series Troubleshooting Guide for the WF-9800-AD Series Deck Mount
found on page 11 of this manual.
SAFETY & PROTECTION FEATURES
WF-8900-AD Series Converter-Charger Features
REVERSE BATTERY HOOKUP PROTECTION
The WF-9800-AD Series Converter-Chargers will charge the 12-volt house battery if installed.
When a battery is installed, two reverse polarity fuses are installed to protect the converter
circuitry. The fuses are located on the rear panel of the enclosure near the AC power cord (refer
to Figure 2 below). This feature prevents permanent damage to the converter from a battery
connected into the circuit backwards. In addition to protecting the converter-charger, the reverse
polarity fuses are the main connection between the converter-charger and the DC fuse board of
a distribution center. A battery does not have to be installed for WF-9800-AD Series
Converter-Charger’s operation.