Wexiodisk WD-12S, Инструкция по установке и эксплуатации

Страница: 27 / 56

WD-12S Rev. (202103)
Installation instructions
23
Side support for corner-loading
A=Connection sink
B=Connection conveyor
The connection profile must look like the one shown in the drawing. The distance
of 6 mm may be reduced, but must not be less than 3 mm.
• Attach the sink connection to the machine and then adjust.
• Drill two ø 4.5 mm holes through the sink connection and the machine,
approx. 100 mm from each outer edge.
• Countersink the holes.
• Seal with silicone between the connection and the machine.
• Secure the sink with countersunk M4 screws, grommets on the outside
surface and nuts. Alternatively, you can secure the sink to the wall with wall
brackets.
Use a spirit level to check that the sinks are horizontal and adjust the height, if
necessary.
310486
A
B
A
A B
B
50
50
50
3
20
6
6
20