Wetif VMT12, Руководство пользователя

Страница: 46 / 95

7
3.2.2.10 Inverter Power Connector (CN13)
VMT12
Motherboard can p5 V and +12 V and signal to LCD
inverter board via CN13.
3.2.2.11 USB Connectors (CN14, CN15, CN24, CN25)
The board provides up to six USB (Universal Serial Bus) ports. This
gives complete Plug and Play, and hot attach/detach for up to 127
external devices. The USB interfaces comply with USB specification Rev.
2.0 which supports 480 Mbps transfer rate, and are fuse protected.
There are 5 x 2 pin 180D (M) connectors for internal use, 4 x USB ports
at CN14, CN15 and two external USB port at CN24,CN25. You will need
an adapter cable if you use a standard USB connector. On one end the
adapter cable has a 5 x 2-pin connector with a foolproof connection to
prevent it from being plugged in the wrong way and on the other end a
USB connector.
3.2.2.12 VGA/LCD/LVDS Interface Connections
The board's PCI VGA interface can drive conventional CRT displays and
is capable of driving a wide range of flat panel displays, including
passive LCD and active LCD displays. The board has connectors to
support these displays: one for standard CRT VGA monitors and one for
flat panel displays
CRT display connector (CN27)
The CRT display connector is a box header connector used for
conventional CRT displays.
LVDS LCD panel connector (CN16)
The board supports 18bit LVDS LCD panel displays. Users can connect
to a 18bit LVDS LCD on it.
3.2.2.13 Ethernet Configuration (CN18, CN19)
10/100/1000 Mbps connections are made via RJ-45 connectors.
The board is equipped with 2 high performance PCI Ethernet interface
which is fully compliant with IEEE 802.3u 100Base-T & IEEE 802.3ab
1000Base-T. It is supported by all major network operating systems.