SETUP INSTRUCTIONS
OPERATING INSTRUCTIONS
+/- LEVEL CONTROL FOR CHANNELS 5/6
MIDDLE BUTTON HAS NO FUNCTION
POWER
INDICATOR
SIGNAL VOLTAGE
INDICATORS
SIGNAL VOLTAGE
INDICATORS
No light
- Signal level low
Blue light
- Ideal Signal level
Red light
- Signal level is too high
SENSITIVITY ADJUSTMENTS
+/- LEVEL CONTROL FOR CHANNELS 7/8
For setup, be sure that the output cables of the WW-8CH-LD are disconnected.
STEP 1: The sensitivity adjustments are found under a cover plate that is secured in
place with three screws. For setup, remove these screws and cover plate.
STEP 2: Connect source unit to input cable and begin playing music. Increase volume
on source unit to the maximum usable output. You will now use the signal voltage
indicators to set the sensitivity adjustments.
STEP 3: Watch the signal voltage indicator lights as you make adjustments. The blue
lights represent the ideal sensitivity setting. If you do not see any lights, the level should
be increased. If you see any ashes of the red light, the level should be decreased.
After all 4 zones have been set, turn volume down, pause music and
connect output cables.
STEP 4: With all components connected, play system. To balance system components,
turn down the adjustment of the components that appear louder. Keep in mind that
if at any point, you are seeing a red signal voltage indicator light ash, you are over-
driving WW-8CH-LD and possibly the component connected to that zone. Once system
is setup, replace the cover plate for the adjustments.
