ADJUSTING VIEW ANGLE
There are 5 holes on both side of the helmet (see Fig.2). You can change view angle
position by moving the adjustable limitation washer into different holes.
NOTE:
SMAW – Shielded Metal Arc Welding
MIG (Heavy) – MIG on Heavy Metals
SAW – Shielded Semi-Automatic Arc Welding
TIG, GTAW – Gas Tungsten Arc Welding
PAW – Plasma Arc Welding
MIG (Light) – MIG on Light Alloys
PAC – Plasma Arc Cutting
MAG/CO² - Metal Active Gas
TROUBLE SHOOTING
Irregular Darkening or Dimming
Headband has been set unevenly on the two sides of the helmet resulting in an uneven
distance from the eyes to the filter lens. (Adjust the headband to reduce the difference in
distances to the filter).
Auto-Darkening filter does not darken or flickers
Helmet was not properly charged before first use. (See “Before First Use” section
on page 2 of this manual.)
Front cover lens is dirty or damaged. (Change the cover lens).
Sensors are dirty. (Clean the sensors surface).
Slow response when darkening
Operating temperature is too low.(Do not use at temperatures below -10ºC or 14ºF)
MAINTENANCE
