WestOz Wireless 9000P, Руководство пользователя

Страница: 8 / 13

9000P Wireless Alarm Owner’s Manual
Page 8
Pairing Sensors
Pairing is the process of linking new sensors to your main Alarm/Siren module. This is a
similar process to pairing a Bluetooth headset with a Cell phone. First the main Siren
module is put into pair mode so that it searches for available sensors to pair with and
then a sensor is put into pair mode to link it to the Siren. This process is described in
detail below:
Putting Alarm Siren into Pair Mode
There are 3 ways of putting the Alarm Siren into pair mode. The first is at time of initial
battery installation and the others are typically used when adding a sensor to an existing
system and utilize either the PIN Pad or the Key Fob to place the Alarm Siren into pair
mode.
Method A – button inside the Alarm Siren
•
Install the three AA batteries into the main Alarm/Siren unit.
•
Press and release the black program button located on the circuit board next to the
battery compartment.
•
The unit will beep twice, green LED flashes slowly searching for a signal for the next
60 seconds.
•
If any of the LED indicator(s) flash Red rapidly, the pairing attempt was unsuccessful
and you will need to start the pairing process again.
Method B – using the PIN Pad
•
Using the PIN Pad, hold down the # key for 3 seconds.
•
The red PIN Pad lights will begin to flash.
•
Wait until the lights on the PIN Pad stop flashing
•
Enter 1 ‐ 6 ‐ #
•
The Siren will beep twice, its green LED flashes slowly searching for a signal for the
next 60 seconds.
•
If any of the LED indicator(s) flash Red rapidly, the pairing attempt was unsuccessful
and you will need to invoke the pairing process again.