1 Fill the
Hopper
with the material you intend to grind.
2. Position a bowl or plate under the
Grinding Plates
to catch the material as it is
being ground.
3. Slowly turn the
Handle
clockwise.
4. Inspect the material that has been ground.
NOTE:
Depending on the type of material that is being ground and your personal
preferences, you may need to adjust the
Pressure Screw
to achieve your desired
results.
FOR COARSE GRINDING:
Loosen the
Wing Nut
and turn the
Pressure Screw
counter
clockwise – this will increase the gap in the
Grinding Plate
, resulting in a coarser grind.
Then re-tighten the
Wing Nut
and resume grinding.
FOR FINE GRINDING:
Loosen the
Wing Nut
and turn the
Pressure Screw
clockwise
– this will decrease the gap in the
Grinding Plate
, resulting in a finer grind. Then re-
tighten the
Wing Nut
and resume grinding.
GRINDING INSTRUCTIONS
• Always make sure the material you are grinding is completely dry.
Material that contains moisture will decrease the performance of the
Mill.
• Turn the
Handle
at constant speed, try to avoid starting and stopping the
Handle
while grinding.
• If the
Mill
becomes jammed and the
Handle
will not turn, briefly turn the
Handle
counter-clockwise to remove jam. Resume normal grinding.
• Do Not fill the
Hopper
with more material than what you plan on grinding.
• Always make sure the
Mill
is securely attached to work surface before you start
grinding .
TIPS FOR EASY OPERATION
-4-
-5-
1. Clamp the
Main Body
to the edge of a table or counter top. Make sure the
Rubber Protector Plate
is positioned on the
Foot
to prevent damage to the work
surface.
NOTE:
The maximum recommended thickness of the clamping surface should not
exceed 1½”.
2. Insert the
Auger
and
Adjustable Grinding Plate
into the
Main Body.
3. Install the
Shield
with
Grinding Plate Pressure Screw
onto the
Main Body.
4. Position the
Rotating Thumbscrews
into the slots in the
Main Body
and securely
tighten.
5. Set the
Adjustable Grinding Plate Pressure Screw
and securely tighten the
Wing Nut
against the
Shield.
6. Install the
Handle
onto the end of the
Auger.
7. Secure
Handle
to the
Auger
using the
Thumbscrew
and attached
Cap Washer.
8. Install
Hopper
onto the top of the
Main Body.
ASSEMBLY INSTRUCTIONS
.
Before using for the first time, you must completely disassemble the
Cereal & Grain
Mill
and thoroughly clean all parts with hot water and dish detergent. Rinse with clean
water and dry thoroughly.
.
For cleaning between uses, simply brush away any left over material with a towel or
medium bristle brush.
.
DO NOT clean any parts of the
Multi-Grain & Cereal Mill
in a dishwasher.
CLEANING INSTRUCTIONS
