Westmed Vibralung Acoustical Percussor, Инструкция по эксплуатации

Страница: 3 / 14

INCLUDED PARTS
The Vibralung AcousEcal Percussor is supplied in two boxes . One box holds the reusable Treatment Control Unit (A),
Pole-­‐mount Bracket (B), and BaYery Charger (C). The other box holds the disposable Hand-­‐held Transducer assembly (D)
plus Standard Y-­‐adapter, mouthpiece and Variable Expiratory Resistor (E), plus an Aerosol Y-­‐adapter (F) that can be used
for aerosol delivery. You should have all the following parts (images not to scale):
Treatment Control
Unit (TCU) BaQery Charger
Standard Y-­‐adapter
Aerosol Y-­‐adapter
Pole-­‐mount Bracket
(pole not included)
A"
!
!
!
!
!
!
!
!
!
!
B" C" D"
E"
!
!
!
!
!
!
!
!
!
!
F"
!
Hand-­‐held Transducer (HHT)
A cable (not shown) emerges from
the boYom of the handle for
connecEng the HHT to the TCU
Mouthpiece
Inspiratory
Valve
(purple cap)
Variable
Expiratory
Resistor
for PEP
Screw-­‐on Cone
PREPARING THE TCU FOR FIRST USE
Page 3
Follow these steps to charge, test and set up the Treatment Control Unit (TCU) for the first (me.
1. Remove the TCU (A), Pole-­‐mount Bracket (B) and BaYery Charger (C) from their shipping box.
2. Mount the TCU on any pole between ¾ and 1¼ inch in diameter using the supplied Pole-­‐mount Bracket as shown in
the figure above. Alternately, simply set the TCU on a flat surface.
3. Plug the BaYery Charger into a standard 120 volt electrical outlet and plug the end of the baYery charger cable into
the boYom jack on the len side of the TCU. (The BaYery Charger plug will not fit in the top jack on the len side of
the TCU). All 9 Light Emipng Diodes (LEDs) should flash 3 Emes quickly and then the Charging and Power LEDs
should stay on during the charging process.
4. Leave the BaYery Charger plugged in and connected to the TCU unEl the TCU’s internal baYeries are fully charged
(which should take no more than 4 hours). The Charging LED will go out and the Power LED will flash when the
unit is fully charged.
5. Disconnect the BaYery Charger aner baYeries are charged, as the TCU will not operate while the charger is
connected.
6. Aner charging is completed and the charger is disconnected from the TCU, perform a Power On Self Test (POST) to
verify that the TCU sonware and processor is operaEng properly: Turn the TCU on by pressing the Power control
buYon once. The POST will occur immediately as shown by all 9 LEDs flashing 3 Emes. If the TCU passes the POST,
the Pause and Power LEDs will remain illuminated. If other LEDs are illuminated, or if no LEDs are illuminated, the
TCU failed the POST and should not be used. Contact Westmed Customer Service (see page 10).
7. The Treatment Control Unit (TCU) is now ready for use. Repeat these steps every Eme the baYery needs to be
recharged, as indicated by the Low BaYery LED.
Handle