
9
PRODUCT MANUAL
1800 358 101
www.westlab.com.au
+64 9 553 3677
www.westlab.co.nz
646 568 5391
www.westlab.com
1 877 822 1455
www.westlab.com
Australia
New Zealand
United States
Canada
3. Press the ‘Increment/Decrement’ button to modify the cycle time between
30 seconds and 90 seconds. Once the cycle time is modified, it will automatically
save after blinking five times.
4. Press the ‘Pulse’ button once to start the pulse mode operation with the modified
cycle time.
5. Press the ‘Pulse’ button again to stop the pulse mode operation. The user can also
press the ‘Start/Stop’ button to stop the ongoing pulse mode operation.
Program mode
The program mode feature allows the user to save up to nine programs with different
speed and time parameters. Users can use any of these programmed parameters by
turning on the program mode.
1. To turn ON the program mode, hold down the ‘Prog.’ button until the ‘Prog. ON’
displays indicating that the program mode has been activated.
2. After a few seconds, the display will display ‘P1’ and ‘speed and time value’
alternatively. This demonstrates the at current program is P1 with set RPM
and time values.
3. Press the ‘Pulse’ button to select any program from the ‘P1 to P99.’ Programs can
also be selected by pressing the ‘Increment/Decrement’ button.
4. Once a program is selected, press the ‘Speed’ button to select and set the
speed value.
5. Press the ‘Time’ button to select and set the time value.