7
EN
1. Attach the outer tube (13) to the base (15) with the 4 screws
(14) as shown.
2. Loosen the knob (11) on the outer tube and extend the inner
tube (10) to the desired height.
3. Slide the cover ring (12) down the outer tube to rest on top of
the base.
Caution: The knob must be fully tightened before assembling the
fan head to the inner tube.
4. Tighten the small screw (9) which is pre-screwed into the small
hole of the inner tube.
5. Position the rear grille (5) over the motor (8) shaft, ensuring
that the notches are correctly aligned, and then secure with the
locking nut (4).
6. Align the fan blade (2) with the flat part of the motor (8) shaft,
and secure by tightening the fan blade screw (3) fully. The
screw should be positioned on the flat part of the motor shaft.
7. Position the front grille (1) against the rear grille (5) and push
the guard ring in place so that it holds both grilles together.
OPERATING INSTRUCTIONS
1. Place the fan on a dry, level surface.
2. Make sure the rotary switch is at the “0” (OFF) position. Plug
the unit into a 120V AC, 60 Hz outlet.
3. Adjust the fan head vertically to the desired angle.
4. To turn on the unit, turn the rotary switch to the “1” (LOW), “2”
(MEDIUM) or “3” (HIGH) position.
5. To stop the unit, turn the rotary switch to the “0” (OFF)
position, and then unplug the unit from power outlet.
6. Unplug the product from the electrical outlet when it is not in
use or is left unattended.
HOW TO USE
WSFS1808BK_18 Oribit Oscillating Fan_2L.indd 7
5/12/2019 18:27:17