Westinghouse WSF6725I, Руководство пользователя

Страница: 10 / 24

If one of program monitor lights is on and
start/pause light is flashing
• Your machine’s door is open, shut the door
to continue�
If the program won’t start
• Check if the plug is connected�
• Check your indoor fuses�
• Check that the water inlet tap is turned on�
• Check that you have closed the machine door�
• Check that you switched off the machine by
pressing the power on/off button�
• Check that the water inlet filter and the machine
filters are not clogged�
If the control light is off after a wash operation
• The power on/off button isn’t released yet�
If detergent residues are left in the detergent
compartment
• Detergent has been added when the detergent
compartment was wet�
• Large dishes have blocked the dispenser door�
If water is left inside the machine at the end of the
program
• The water drain hose is clogged or twisted�
• The filters are clogged�
• The program is not finished yet�
TIPS & INFORMATION
IMPORTANT
At the end of the program, water may still remain on the
sides and door of the appliance.
If the machine stops during a wash operation
• Power failure�
• Water inlet failure�
• Program is on standby mode�
If shaking and hitting noises are heard during
a wash operation
• Dishes are placed incorrectly�
• The spray arm is hitting the dishes�
If there are partial food wastes left on the dishes
• Dishes are placed incorrectly into the machine,
sprayed water did not reach related places�
• Basket overloaded�
• Dishes leaning against one another�
• Very small amount of detergent added�
• An unsuitable, rather weak wash program selected�
• Spray arm clogged with food waste�
• Filters clogged�
• Filters incorrectly fitted�
• Water drain pump clogged�
If there are white stains on the dishes
• A very small amount of detergent is being used�
• Rinse aid dosage setting at a very low level�
• Water hardness is very high�
If the dishes won’t dry
• A program without a dry operation selected�
• Rinse aid dosage set too low�
• Dishes unloaded too fast�
• Use a hotter program
If there is rust on the dishes
• Stainless-steel quality of the dishes washed
is insufficient�
• High level of salt in the wash water�
• Unhealthy mains grounding�
Unloading the baskets
• For improved drying results with the most effective
use of energy, open the door approximately 10cm at
the end of the program�
• Allow the tableware to cool for 30-40 minutes as hot
items can easily be damaged�
• First remove items from the lower basket before
removing the items from the upper basket�
Call an authorised service if the problem still
persists after the controls or in case of any
malfunction not described above.
Useful Information
• Whenever you will not be operating your machine:
- Unplug the machine and then turn water off�
- Leave the door slightly ajar in order to prevent the
formation of unpleasant smells�
• Keep the machine interior clean�
• Correct loading of dishes in the machine, enables
reduced energy consumption and improved washing
and drying performance�
• Remove all large food remnants before you placing
dirty dishes into the machine�
• Operate the machine after it is completely full�
• If the appliance is located in a place where the risk of
freezing exists, you must completely drain the water
that has remained in the machine� Turn off the water
tap, disconnected the water inlet hose from the tap
and allow the interior water to drain�
HINTS AND TIPS
10
HINTS AND TIPS