Westinghouse WFTR40W, Руководство пользователя

Страница: 6 / 12

Page 6
SET UP & USE
ASSEMBLY OF PEDASTAL AND BASE
PEDESTAL ASSEMBLY
• Line up the left and right pedestal suports and firmly snap together
(Fig. 1).
BASE ASSEMBLY
• Align the two portions of the circular base and snap together by
gently pushing the 4 extrusions (Fig. 2, Item A) into the adjacent
circles of the connecting piece (Fig. 2, Item B).
SECURING THE PEDESTAL TO THE BASE
• Align the 3 screw holes on bottom of pedestal with the 3 holes in
the base such that the power cord cut out is at the rear of the unit .
(Fig. 3)
• Secure the base assembly to the pedestal by inserting and
tightening the 3 screws in the 3 holes located on the bottom of the
base (Fig. 4).
SECURING THE TOWER FAN TO THE PEDESTAL
• Carefully turn the fan on its side and place on a table. Place the
power cord through the center of the pedestal and base assembly.
• Align the pedestal with the tower fan so that the one locking screw
hole on the pedestal body is aligned with the rear of the tower fan
unit. Firmly hold the base steady and rotate the pedestal support
clockwise to lock the tower fan into the pedestal support (Fig. 5).
• Secure the pedestal to the tower fan by inserting and tightening
1 screw in the opening located near the top rear of the pedestal
support (Fig. 6).
SECURING THE CORD TO THE BASE
• With the fan still on its side, locate the cord holding bracket on the
bottom of the base.
• Gently pull any slack out of the power cord, place the power cord
securely in the holding channel and secure the power cord bracket
over the power cord (Fig. 7).
• Return the tower fan to its upright position.
NOTE: Do not operate the tower fan unless it is in its proper, upright position and
pedastal / tower screw is installed. (See Fig.6)
SET UP & USE
Fig. 1
Pedestal Assembly
Fig. 5
Fig. 7
Fig. 6
Fig. 4
A
B
Extrusions
Fig. 2
Base Assembly
Fig. 3
Positioning
Hole
Positioning
Pole