05/29/2018
2/2E
WARNING:
Do not dispose of Ni-Mh batteries in municipal waste stream or by fire as batteries may explode. Do not open, short circuit, or mutilate
batteries. Dispose of batteries in accordance with Local, State, and Federal regulations. Do not mix old and new batteries. Do not mix alkaline,
standard (Carbon-Zinc), or rechargeable (Nickel Cadmium or Nickel Metal Hydride) batteries .
LINKABLE SET-UP INSTRUCTIONS
ITEM: Q08BN0301-08
For additional help and information regarding installation, contact customer service at 1-844-551-0680, 8am-5pm, CST Monday – Friday
, WESTINGHOUSE, are trademarks of Westinghouse Electric Corporation. Used under license by Sky Rich Star Limited. All Rights Reserved.
1) Make sure the LED lights are directed away from your eyes then move
the power switch to the on position.
2) Among all the lights, select one as the Parent light, and the others
as the Child lights.
3) Child Lights - Move the link button to the on position on all Child
lights you want to connect to the Parent light.
Remain in the on position for 3 seconds, then move back the Link
button.
The child lights will turn to flashing status (flash every 1 Second).
The Child lights are now waiting for a receiving signal from the
Parent light for code matching.
4) Parent light: Move the Link button to the on position. Leave in on
position for 5 seconds, the Parent light will flash very slowly
(flashing every 4 Seconds). The Parent light is sending the
matching signal/codes to the Child lights.
5) Once the Child lights receive and save the matching
signal the blinking light on the Child lights will stop flashing,
this confirms the code matching is completed.
6) When all Child lights are matched successfully, move back the
link on button for Parent light. The code matching is finished
and products are Linked. When any of the lights are triggered
by the Motion Detector, all lights will activate.
Link button
Power switch
FCC WARNING
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user authority to
operate the equipment.
Notes: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These linits are designed to protection against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency enerqy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no quarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio / TV technician for help.
