Westinghouse PT20360, Инструкция по эксплуатации

Страница: 3 / 10

GENERAL SAFETY RULES
SPECIFIC SAFETY RULES
3
Tool Use and Care
1.
Use clamps or other practical way to secure and support the work piece to a stable platform.
Holding the
work piece by hand or against your body is unstable and may lead to loss of control.
2. Do not force the tool. Use the correct tool for your application. The correct tool will do the job better and
safer at the rate for which it is designed.
3. Do not use the tool if the switch cannot be turned on or off. Any tool that cannot be controlled with the switch
is dangerous and must be repaired before use.
4.
Disconnect the plug from the power source before making any adjustment, changing accessories, or
storing the tool. Such preventive safety measures can reduce the risk of starting the tool accidentally.
5. Store idle tools out of reach of children or other untrained persons. Tools are dangerous in the hands of
untrained users.
6. Maintain tools with care. Keep the cutting tools sharp and clean. Properly maintained tools with sharp
cutting edges are less likely to bind and are easier to control.
7.
Check for misalignment or binding of moving parts, breakage of parts and any other condition that may
affect the tools operation. If damaged, have the tool serviced before using. Many accidents are caused by poorly
maintained tools.
8.
Some accessories suitable for one tool may become hazardous when used on another tool.
Please check
all accessories to be used are suitable.
Service
1. Tool service must be performed only by qualified repair personnel. Service or maintenance performed by
unqualified personnel could result in a risk of injury.
2. When servicing a tool, use only identical replacement parts.
1. Always use proper guard with grinding wheel.
A guard protects operator from broken wheel fragments.
2. Accessories must be rated for at least the speed recommended on the tool warning label. Wheels and
other accessories running over rated speed can fly apart and cause injury.
3. Hold tool by insulated gripping surfaces
when performing an operation where the cutting tool may contact
hidden wiring or its own cord.
4. Make sure the grinding wheel is not contacting the work piece before the switch is turned on.
5. Grinding wheel and guard must be securely attached
as described in this operating manual before
connecting the angle grinder to power source.
6. Grinding wheel must be stored in a dry place.
7. Always hold the grinder firmly with two hands
while working and at all times when it is running.
8. Use only quality certified grinding wheels.
9. Keep hands away from rotating parts.
10. Be careful not to damage the spindle, outer flange and inner flange.
Damage to these parts could result in
wheel breakage.
When starting the tool (install with a new or replacement wheel) , hold the tool in a well protected area and let it
run for one minute to check if the wheel is good or not. Never starting the tool while the operator is standing at in line
with the wheel.